742883
64
Zoom out
Zoom in
Previous page
1/178
Next page
57
If you want to log in to the CPEs in client mode (LED1, LED2, and LED3 are blinking) after one-to-multiple
bridge, connect the computer to the PoE/LAN port of the corresponding CPE you want to log in one by
one using an Ethernet cable, and visit 192.168.2.2.
If you want to log in to the CPE in Router mode, perform the following procedure.
Step 1 Connect the computer to the wireless network using the SSID and password set on the
CPE.
Step 2 Visit the LAN IP address you set for the CPE.
----End
After performing the steps above, If you still cannot log in to the web UI, refer to the following
descriptions to solve the problem.
Ensure that the device has been connected to a power source and the computer properly.
Ensure that the IP address of the login computer is 192.168.2.X (X ranges from 2 to 254).
If the CPE has performed one-to-one bridge, its IP address is changed to 192.168.2.2. Visit the
new IP address for login.
If the CPE is set to Router mode, the PoE/LAN port is changed to a WAN port. You need to
connect to the wireless network of the CPE, and visit its LAN IP address for login.
Restore the device to factory settings. Method: After the CPE is powered on for about 1 minute,
hold down the Reset button for about 8 seconds and release it when all LED indicators light up.
2.2 Logout
You can click Logout on the upper-right corner of the web UI to logout. When you close the web
browser, the system logs you out as well.
If you log in to the web UI of the device and perform no operation within the login timeout
interval (default: 5 minutes), the device logs you out.
64


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tenda O4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tenda O4 in the language / languages: English as an attachment in your email.

The manual is 5,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info