742873
11
Zoom out
Zoom in
Previous page
1/84
Next page
2 Installing the AP
2.1 Preparing for Installation
Before installing the AP, follow the instructions in this section to make preparation.
2.1.1 Precautions
To prevent damaging the AP or causing a personal injury, pay attention to the following precautions:
Ensure that the temperature and humidity requirements specified in the following table are met.
Environment
Temperature
Humidity
Operating
environment
C - 45°C
10%RH - 90%RH (non-condensing)
Storage environment
-40°C - 70°C
5%RH - 90%RH (non-condensing)
Ensure that the AP is mounted on a place free of accumulated water and water drips. Do not install the
AP in a wet environment.
Do not open or remove the housing of the AP.
Keep the AP clean.
Before cleaning the AP, disconnect it from the power supply. Do not scrub the AP with any liquid.
2.1.2 Preparing Tools
You may need a rubber hammer, a marker, a hammer drill, a spirit level, a measuring tape, a 6 mm drill bit, a
Phillips screwdriver, ESD gloves, and a ladder during installation. Prepare them yourself.
Rubber hammer
Marker
Hammer drill
Spirit level
Measuring tape
6 mm drill bit
Phillips screwdriver
ESD gloves
Ladder
2.2 Installing the AP
Step 1 Place the mounting bracket onto the target position of the ceiling and mark the positions of the screw
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tenda i12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tenda i12 in the language / languages: English as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info