Manual Telwin STARTRONIC 330 (page 10 of 44) (All languages)

627242

Zoom out

Zoom in

1/44

FUNCTION.The CHARGE function permits initial charging STAND-BY power supply unit.

of the battery at constant current with the value previously

set, for a maximum time of 10 hours. If the battery voltage is

= indicates:

particularly low, a fixed current of 2A will be delivered until

- No battery voltage

1.5 V/e is reached; once this threshold has been reached

- Low battery voltage

this current until the end-of-charge limits for that particular

= inversion of polarity.

type of battery are reached. Once this time has elapsed, if

the battery has not reached a certain battery voltage level

All the alarm conditions prevent the delivery of

(stored inside the microcontroller) a further 2 hours are

current to the battery except for the auxiliary power

added after which the battery charge is switched off. If the

supply unit which is equipped with independent

battery charger reaches the reference voltage before the

safety devices.

end of the 10 charging hours pre-set in the control circuit the

battery charger switches off without adding the extra

PRECAUTIONS:

two hours.

The STARTRONIC battery-charger/starter is a

The START function permit starts at CONSTANT

microprocessor controlled electronic device that is able to

VOLTAGE, automatically limiting the current to the pre-set

protect the vehicle electronics from voltage surges that may

values with cycles lasting "5 sec ON" and "20 sec OFF".

be generated when particularly flat or sulphated batteries

Blinking of the STARTled indicates that this function is

are being charged. In this case its protective capacity is

enabled.

shown as it blocks the charge function every time the ON

key is pressed: a fraction of a second is sufficient to evaluate

(CHARGE) Charge current selection key

the battery status and automatically discontinue charging

This key is used to select the charge current level in

when there is evidence of dangerous voltage surge risks to

"CHARGE" mode .

the automobile devices that are connected electrically to the

The charge currents that can be set are

battery terminals.

WARNING: select the charge voltage in accordance with

2/5/10/20/30 A

the rated voltage of the battery to be charged.

By setting the key to START, the current available is 170 A

for the model ST300.

CHARGING VERY FLAT OR SULPHATED BATTERIES

WARNING: when charging in this situation the automobile

(DISPLAY) Current/voltage key

electronics are not protected therefore it is essential to

Three different displays can be selected with this key:

disconnect the battery from the vehicle. To be able to charge

- "I": the current delivered in Amps is displayed, both in

such batteries it is necessary to exclude the STARTRONIC

CHARGE and START;(ST 300)

built-in protection against voltage surges that could destroy

- "V": in this position the display indicates the output voltage

the vehicle electronics.

to the battery in Volts;

Excluding this option implies that the battery can be

charged if and only if it is disconnected from the automobile

electronics.

To be able to charge without the support of the protections,

FIG.B-C

press the ON key for at least 5 seconds. Pressing the ON

(ON) Switch-on Key

key for more than 5 seconds causes the STARTRONIC to

This key identified by "I" allows to deliver power to the

enter an operating mode without checks on any voltage

battery.

surges that could be generated when the battery being

IMPORTANT: before pressing this button ensure that you

charged is in very poor condition: the charging process will

have previously performed all the required settings.

not stop until either the operator chooses to press the OFF

If the function selected with the key (I) is START, the battery

key or a preset time limit has been reached.

charger will begin to deliver starting current only when

At the end of this stage, which is indicated by the flashing of

requested by the vehicle.

the general alarm LED, the STARTRONIC returns

automatically to protected operating mode which ensures

(OFF) Switch-off Key

the elimination of voltage surge risks.

This key, identified by "O", interrupts delivery of the current

to the battery/batteries during charge or start.

WARNING: the machine is still powered.

_______________(D)______________

ANLEITUNGSHANDBUCH

(E) Battery charge status indicator key

The three leds indicate the battery status by reading its

voltage. The upper led indicates that the battery is charged

by reading a battery voltage equal to or higher than the end-

of-charge voltage. The middle led indicates that the battery

is still able to receive current but that the charge level is

acceptable. The lower led indicates that the battery is flat.

(F) Alarms and safety devices key

The equipment is protected against overloads, short circuits

Die Modelle ST 500 und ST 300 sind Monophase

and inversion of polarity by means of internal electronic

Ladegerät/ Starter, Speisung 230 Vac 50/60Hz, das

safety devices.

elektronisch mit konstantem Strom und konstanter

There are 3 leds:

Spannung von einem Mikrokontroller kontrolliert werden:

= cut-in of the thermostatic safety device except for the

Sie ermöglichen die Ladung von Bleibatter ien mit freien

ACHTUNG:

VOR GEBRAUCH DER MASCHINE LESEN SIE

SORGFÄLTIG DIE BETRIEBSANLEITUNG

ST 500-300

- 10 -

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telwin STARTRONIC 330 in the language / languages: All languages as an attachment in your email.

The manual is 1,54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Telwin STARTRONIC 330 Manual

Product: