Manual Telwin NEVABOOST 140 (page 2 of 60) (All languages)

627096

Zoom out

Zoom in

1/60

protected against indirect contacts by an earth lead as

_____________( GB )______________

required for class I equipment.

INSTRUCTION MANUAL

3. INSTALLATION

ASSEMBLY (FIG.A)

- Unpack the battery charger and assemble the separate

parts contained in the package.

- Models on wheels are to be set in a vertical position.

WARNING: BEFORE USING THE BATTERY CHARGER

POSITIONING THE BATTERY CHARGER

READ THE INSTRUCTION MANUAL CAREFULLY.

- During operation, position the battery charger on a stable

surface and make sure that there is no obstruction to air

1. GENERAL SAFETY RULES WHEN USING THIS

passage through the openings provided to ensure

BATTERY CHARGER

sufficient ventilation.

CONNECTION TO THE MAIN SUPPLY

- The battery charger should be connected only and

- During the charge the battery produces explosive gases,

exclusively to a power source with the neutral lead

avoid the formation of flames and sparkes. DO NOT

connected to earth.

SMOKE.

Check that the mains voltage is the same as the voltage of

- Position the batteries to be charged in a well-ventilated

the equipment.

place.

- Check that the power supply is protected by systems such

as fuses or automatic switches, sufficient to support the

maximum absorption of the equipment.

- The connection to the main supply has to be made using a

suitable cable.

- Inexperience and untrained people should be

- If you put an extension to the primary cable, the section

properly instructed before using the appliance.

should be adequate and, in any case, never less than that

- People (children included) whose physical, sensory

of the cable supplied.

or mental capacities would prevent them from using

- You always have to earth the equipment with the

the appliance correctly must be supervised by a

yellow/green wire contained in the main cable, indicated

person who is responsible for their safety while the

by the label ( ), while the other two wires should be

appliance is in use.

connected to the mains.

- Children must be supervised to ensure that they do

not play with the appliance.

4. OPERATION

- Use the battery charger only indoors and make sure that

BEFORE CHARGING

you start it in airy places. DO NOT SET IN THE RAIN OR

NB: Before charging check that the capacity of the

SNOW.

battery (Ah) which is to be charged, is not inferior to that

- Disconnect the mains cable before connecting to or

reported on the data table. (C min).

disconnecting the charging cables from the battery.

Follow the instructions, taking great care to respect the

- Do not connect or disconnect the clamps to or from the

order given below.

battery with the battery charger operating.

- Remove the caps of the battery charger (if foreseen) so as

- Never use the battery charger inside the car or in the

to let the gas produced go out.

bonnet.

- Check that the level of the electrolyte covers the plates of

- Substitute the mains cable only with an original one.

the battery. If these were not covered add distilled water

- Do not use the battery charger to charge batteries which

and cover them up to 5-10 mm.

are not rechargeable.

- Make sure the available power supply voltage

WARNING: USE THE MAXIMUM CAUTION DURING

corresponds to that shown on the battery charger rating

THIS OPERATION AS THE ELECTROLYTE IS A HIGHLY

plate.

CORROSIVE ACID.

- To avoid damaging the vehicle's electronics, read, keep

- Please remember that the exact charge status of the

and take very careful note of the information supplied by

battery can only be determined by using a densimeter

the vehicle manufacturer, when using the battery charger

which allows measurement of the specific gravity of the

either for charging or starting; the same applies to the

electrolyte the following indicate approximate density

instructions supplied by the battery manufacturer.

values for the solute (Kg/l at 20°c):

- This battery charger has components such as switches

1.28 = charged battery

and relays which can cause arcs or sparks. Therefore

1.21 = half-charged battery

when using it in a garage or in a similar place set the

1.14 = flat battery

battery charger in a suitable case.

- With the power supply cable disconnected from the main

- Repair or maintenance of the inside of the battery charger

power supply outlet, position the 6/12 V or 12/24 V switch

can be executed only by skilled technicians.

(if present) according to the rated voltage of the battery to

- WARNING: ALWAYS DISCONNECT THE POWER

be charged.

SUPPLY CABLE FROM THE MAINS BEFORE

- Position the switch/es for adjusting the type of charge (if

CARRYING OUT ANY SIMPLE MAINTENANCE

present) as required (FIG.B. LOW normal charging,

OPERATION ON THE BATTERY CHARGER.

HIGH rapid charging).

- Make sure the power outlet is protected by an earth

- Check the polarities of the battery terminals: positive for

connection.

the + symbol and negative for the - symbol.

- For those models without one, connect a plug with

NOTE: if the symbols are indistinguishable remember

suitable capacity in relation to the fuse size shown on the

that the positive terminal is the one not connected to the

data plate.

vehicle chassis.

- Connect the red charge clamp to the positive terminal of

2. INTRODUCTION AND GENERAL DESCRIPTION

the battery ( + symbol).

- This battery charger can be used to charge free

- Connect the black charge clamp to the vehicle chassis, at

electrolyte lead acid batteries used on petrol and diesel

a safe distance from the battery and the fuel pipe.

engine vehicles, motor cycles, boats etc.

NOTE: if the battery is not installed in the vehicle, connect

- The charging current delivered by the battery decreases

the clamp directly to the negative terminal of the battery (-

according to the characteristic W bend - see the DIN

symbol).

41774 norm.

- The charger case has a protection degree of IP 20 and is

- 2 -

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telwin NEVABOOST 140 in the language / languages: All languages as an attachment in your email.

The manual is 1,6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Telwin NEVABOOST 140 Manual

Product: