Manual Telwin NEVABOOST 100 (page 2 of 40) (All languages)

627086

Zoom out

Zoom in

1/40

engine vehicles, motor cycles, boats etc. and is suitable

_____________( GB )______________

for charging sealed batteries.

- Rechargeable batteries according to the output voltage

available: 6V / 3 cells; 12V / 6 cells; 24V / 12 cells.

INSTRUCTION MANUAL

- The charging current delivered by the battery decreases

according to the characteristic W bend - see the DIN

41774 norm.

3. INSTALLATION

POSITIONING THE BATTERY CHARGER

- During operation, position the battery charger on a

WARNING: BEFORE USING THE BATTERY

stable surface and make sure that there is no obstruction

CHARGER READ THE INSTRUCTION MANUAL

to air passage through the openings provided to ensure

CAREFULLY.

sufficient ventilation.

1. GENERAL SAFETY RULES WHEN USING THIS

CONNECTION TO POWER

- The battery charger should be connected only and

BATTERY CHARGER

exclusively to a power source with the neutral lead

connected to earth.

Check that the net voltage is the same as the voltage of

the equipment.

- During the charge the battery produces explosive gases,

- Check that the power supply is protected by systems as

avoid the formation of flames and sparkes. DO NOT

fuses or automatic switches, sufficient to support the

SMOKE.

maximum absorption of welding.

- Position the batteries to be charged in a well-ventilated

- If you put an extension to the primary cable, the diameter

place.

must be the same, never inferior.

- The connection to the power has to be made using the

cable.

4. OPERATION

- Inexperience and untrained people should be

BEFORE CHARGING

properly instructed before using the appliance.

NB: Before charging check that the capacity of the

- People (children included) whose physical, sensory

battery (Ah) which is to be charged, is not inferior to that

or mental capacities would prevent them from using

reported on the data table. (C min).

the appliance correctly must be supervised by a

Follow the instructions, taking great care to respect the

person who is responsible for their safety while the

order given below.

appliance is in use.

- Remove the caps of the battery charger (if foreseen) so

- Children must be supervised to ensure that they do

as to let the gas produced go out.

not play with the appliance.

- Check that the level of the electrolyte covers the plates of

- Use the battery charger only indoors and make sure that

the battery. If these were not covered add distilled water

you start it in airy places. DO NOT SET IN THE RAIN OR

and cover them up to 5-10 mm.

SNOW.

- Disconnect the mains cable before connecting to or

WARNING: USE THE MAXIMUM CAUTION DURING

disconnecting the charging cables from the battery.

- Do not connect or disconnect the clamps to or from the

THIS OPERATION AS THE ELECTROLYTE IS A HIGHLY

battery with the battery charger operating.

CORROSIVE ACID.

- Never use the battery charger inside the car or in the

- With the power supply cable disconnected from the

bonnet.

power outlet, position the 6/12 V or 12/24 V charge

- Substitute the mains cable only with an original one.

switch (if present) according to the rated voltage of the

- Do not use the battery charger to charge batteries which

battery to be charged.

are not rechargeable.

- Check the polarities of the battery terminals: positive for

- Make sure the available power supply voltage

the + symbol and negative for the - symbol.

corresponds to that shown on the battery charger rating

NOTE: if the symbols are indistinguishable remember

plate.

that the positive terminal is the one not connected to the

- To avoid damaging the vehicle's electronics, read, keep

vehicle chassis.

and take very careful note of the information supplied by

- Connect the red charge clamp to the positive terminal of

the vehicle manufacturer, when using the battery charger

the battery ( + symbol).

either for charging or starting; the same applies to the

- Connect the black charge clamp to the vehicle chassis,

instructions supplied by the battery manufacturer.

at a safe distance from the battery and the fuel pipe.

- This battery charger has components such as switches

NOTE: if the battery is not installed in the vehicle,

and relays which can cause arcs or sparks. Therefore

connect the clamp directly to the negative terminal of the

when using it in a garage or in a similar place set the

battery (- symbol).

battery charger in a suitable case.

- Repair or maintenance of the inside of the battery

CHARGING

charger can be executed only by skilled technicians.

- Power the battery charger by inserting the power supply

- WARNING: ALWAYS DISCONNECT THE POWER

cable into the power outlet and turning the switch (if

SUPPLY CABLE FROM THE MAINS BEFORE

present) to ON.

CARRYING OUT ANY SIMPLE MAINTENANCE

- The ammeter (if present) will indicate the current (in

OPERATION ON THE BATTERY CHARGER.

Amps) delivered towards the battery: during this phase

the pointer of the ammeter will decrease slowly to very

low values according to the capacity and condition of the

2. I N T R O D U C T I O N A N D G E N E R A L

battery.

DESCRIPTION

FIG.A

- This battery charger can be used to charge free

NOTE: Once the battery is charged you may note the liquid

electrolyte lead acid batteries used on petrol and diesel

- 2 -

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telwin NEVABOOST 100 in the language / languages: All languages as an attachment in your email.

The manual is 0,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Telwin NEVABOOST 100 Manual

Product: