649701

Telwin DRIVE 9000 Manual

5
Zoom out
Zoom in
Previous page
1/100
Next page
- 5 -
A-7. Starter charging mini USB input port.
A-8. 5V/2A USB output.
A-9. LED light.
A-10. Starter clamps output socket (ref.
A-2)
A-11. Internal battery charge status
indicator LED.
A-12. ON/OFF switch for the charge level,
to control the output port (ref. A-6)
and the LED light.
3. INSTALLATION
POSITIONING THE STARTER
When using the starter, position it on a
horizontal, at and stable surface.
4. OPERATING INFORMATION
4.1 How to use the starter:
WARNING: follow
these instructions
meticulously, and
alwaysintheordergivenbelow!
Always prevent the black and red
clamps from touching each other or a
common cable!
- Make sure that the vehicle or boat to be
started is switched off (switch or ignition
key in the OFF position).
- Connect the red clamp POS. (+) to the
battery terminal POS. (+), then connect
the black clamp NEG. (-) to the vehicle
chassis or the battery terminal NEG. (-),
at a distance from the fuel pipe.
- Check that the Red LED seen in g. A-3
is OFF; if this is not the case, carefully
check that the clamp polarities are
connected correctly and the clamps
are not short-circuited by common
conductive parts.
- Check that only the Green LED seen in
g. A-3 is ON;
- If all the LEDs are OFF, a situation
that occurs when the vehicle battery is
too low, it is possible to force the start
operation by pressing and holding the
“BOOST” button seen in g. A-4 for three
seconds until the Green LED comes on.
WARNING: failure to follow
these rules may compromise
the operating life of the
device:
- Turn the vehicle ignition to the start
position for no more than 3 seconds.
- Ifthe vehicle or boat does not start,
wait at least 15 seconds before trying
again.
- If the vehicle or boat still does not
start, wait at least 2 minutes before
trying again.
After a successful start, with the engine
running, follow the sequence of instructions
below with great care:
- Disconnect the black clamp (negative)
from the vehicle.
- Disconnect the red clamp (positive) from
the vehicle.
- Remove the starter cable connector from
the starter
- Replace the cables and the starter in
their seats inside the case.
It is highly recommended to recharge the
starter as soon as possible.
4.2 Using the starter as a power and/or
chargingdevice:
- Insert the output cable terminal (g.A-5)
into the appropriate USB port on the
starter (g.A-8);
- Press the ON button seen in gureA-12
once;
- Insert the other cable terminal into the
device to be powered;
4.3 Using the LED lights
- Press and hold the ON button (g.
A-12) for a few seconds to enable the
continuous LED light function.
The press the button in the following
sequence:
- once to start the blinking light;
- twice to start the emergency signal;
- three times to switch the light OFF.
5. CHARGING
Important!Toachievemaximumbattery
performance, always charge before use,
then after every time it is used and, in
anycase,atleastevery3months.
It is possible to charge the unit using the
relative cable (g.A-5) connecting the mini
USB terminal to the starter charge socket
(g.A-7) and the other terminal to a USB
output source (e.g. a computer) or to the
12V car cigarette lighter socket using the
adaptor seen in gureA-6.
Press the button seen in g.A-12 once to
check whether the battery needs charging.
The LEDs seen in g. A-11 indicate the
charge status of the battery, which light up
as the status increases:
- one LED only: low battery;
- all LEDs are on: fully charged battery.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telwin DRIVE 9000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telwin DRIVE 9000 in the language / languages: All languages as an attachment in your email.

The manual is 1,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info