681331
163
Zoom out
Zoom in
Previous page
1/180
Next page
163
9.19 Modbus TCP interface
Modbus TCP interface allows the user to set or get some parameters from the router (the parameters, which can
be set or get will be described later), like module temperature or signal strength. In other words, Modbus TCP is another
manner to control router behavior. To use Modbus TCP capabilities it must be turned on by navigating to Services-
Modbus. After “Save” button is pressed, the Modbus daemon will be launched on selected port of the system. Modbus
daemon performs as slave, that means, it accepts connection from the master (client) and sends out a response or sets
some system related parameter. By the default Modbus will only accept connections through LAN interface. In order to
accept connections through WAN interface also, Allow Remote Access must be checked.
To obtain some parameter from the system, the read holding registers command is used. The register number
and corresponding system values are described below. Each register contains 2 bytes. For simplification the number of
registers for storing numbers is 2, while for storing text information the number of registers is 16.
Required value
Representation
Register number
Number of registers
System uptime
32 bit unsigned integer
1
2
GSM signal strength (dBm)
32 bit integer
2
2
System temperature in 0.1 degrees
Celcium
32 bit integer
3
2
System hostname
Text
4
16
GSM operator name
Text
5
16
Router serial number
Text
6
16
Router MAC address
Text
7
16
Router name
Text
8
16
Current SIM card
Text
9
16
Network registration
Text
10
16
Network type
Text
11
16
Digital input 1
32 bit integer
12
2
Digital input 2
32 bit integer
13
2
Current WAN IP address
32 bit unsigned integer
14
2
Analog input
32 bit integer
15
2
The Modbus daemon also supports setting of some system parameters. For this task write holding register
command is used. System related parameters and how to use them are described below. The register number refers to
the register number where to start write required values. All commands, except “Change APN” accepts only one input
parameter. For the APN the number of input registers may vary. The very first byte of APN command denotes a number
163


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teltonika RUT905 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teltonika RUT905 in the language / languages: English as an attachment in your email.

The manual is 8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info