681323
16
Zoom out
Zoom in
Previous page
1/68
Next page
16
Powering Options
The RUT500 router can be powered from power socket (1) or over Ethernet port (applies only to the new hardware
revision*). Depending on your network architecture you can use LAN 3 (2) or WAN (3) Ethernet port to power the
device.
RUT500 can be powered either from power socket or either over Ethernet. Do not connect power supplies to both
power inputs simultaneously.
Also do not use LAN3 and WAN port for powering RUT500 simultaneously.
Use pin 5 of Ethernet port to supply positive voltage and connect pins 7 and 8 ground. Even though only pin 5 is used in
router for positive voltage input, there is a posibility to connect power supplies that uses both pins 4 and 5 for positive
voltage. To power RUT500 using LAN3 or WAN ethernet ports, please make sure, that all jumpers from the pins
J4.1,J4.2, J3.1,J3.2 (show in a picture below) are removed, because there is a great risk of damaging a power supply!
To check if the jumpers were mounted, you need to remove front panel (the one with power socket).
Though the device can be powered over Ethernet port it is not compliant with IEEE 802.3af-2003 standard. Powering
RUT500 from IEEE 802.3af-2003 power supply will damage the device as it is not rated for input voltages of PoE
standard.
* New hardware revision has 7 30VDC written on the device sticker while older revision has 9V 1A
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teltonika RUT500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teltonika RUT500 in the language / languages: English as an attachment in your email.

The manual is 2,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info