7251
10
Zoom out
Zoom in
Previous page
1/41
Next page
Installing the TELES.iTA/2TR Box
© 1998 by TELES AG Berlin, Version 1.30/iTA-eu/f/8.02 Issue: June 1998 Page 5
3.2 Required Settings for Operating TELES.iTA/2TR Box
The TELES.iTA/2TR Box is set via a DTMF/“touch-tone” telephone (DTMF = Dual Tone
Multi Frequency) attached to any port of the box. The telephone should also have a
key
(tone) and a # key (pound/flash). Please refer to documentation that came with your telephone
to determine if your telephone is set to touch-tone dialing. If it isn’t, you should be able to
switch it from dial pulsing to touch-tone dialing.
All settings are made by entering a command sequence beginning with the
key followed by
a command number. Depending on the function desired, you then again enter the
key fol-
lowed by one or more numbers. Each number entered must be preceded by the
key. The
#
key finishes the command sequence.
command no.
number 1
number 2
number 3
#
If a setting was carried out successfully, you will hear a long beep. If a setting was unsuc-
cessful, or if you made a mistake, you will hear a trill.
Besides using a telephone for configuration, you can also make settings using a user-friendly
Windows software. All you need is an ISDN board for your PC – e.g. a TELES.BRI board
with the TELES.OnlinePowerPack application suite. This board should be attached to the
same ISDN line as the TELES.iTA/2TR Box (see section 5.6, page 26).
To configure your TELES.iTA/2TR Box, you must first configure your PIN (Personal Identi-
fication Number).
3.2.1 Configuring the PIN
Several important settings for your TELES.iTA/2TR Box require you to enter a PIN (Personal
Identification Number). The PIN must be a 5-digit number; PIN 00000 is configured by de-
fault. You can only perform one setting using the default PIN and that is configuring the PIN
to another number.
NOTE: It is imperative that you remember your newly configured PIN. We recommend
writing it down and storing it in a safe place. Should you forget your PIN, you will
be unable to change any settings! In this case you have to send your
TELES.iTA/2TR Box back to TELES for maintenance!
To change your PIN, enter the following command sequence:
90oldPINnewPINnewPIN#
Example: To change the PIN from the default setting (PIN=00000) to 01234:
90000000123401234#
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teles iTA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teles iTA in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info