688850
23
Zoom out
Zoom in
Previous page
1/40
Next page
Vers. 001 Energy 2510 G
23
G
B
thoroughly. Let the filter cartridge dry out
completely, then dip it in clean engine oil.
Squeeze out carefully any excess oil.
Replace the cartridge only if visibly worn out.
7.4.3 Spark plug maintenance
For both models of generating sets, use spark
plug models BP6ES, BPR6ES (NGK), W20EP-U,
W20EPR-U (ND) or else spark plugs made by
other manufacturers but compatible with the
above.
Never use spark plugs with a different
temperature degree from those listed above.
Take the cap off the spark plug (Fig.36 Ref.2)
and using the special wrench take out the
plug.
Perform a visual inspection. Replace in case
of obvious wear or if the insulator is broken or
cracked.
Use a steel brush to clean the spark plug, if it
can be used again.
Use a thickness gauge to measure the
distance between the electrodes. The right
distance should be between 0.7 and 0.8 mm
(Fig. 37).
Correct the distance if necessary, bending the
side electrode.
Make sure that the spark plug washer is in
good condition and then screw back on by
hand to make sure that it is correctly put back
in place. Finally, tighten to the right torque
using the special wrench (see instructions in
the engine user and maintenance manual).
When assembling a new
spark plug, tighten by 1/2 turn after the spark
plug has compressed the sealing washer.
If you put back the old plug after having
removed it, tighten it by 1/4 turn after it has
compressed the sealing washer.
The spark plug must be
tightened firmly. A badly positioned spark
plug may become very hot and damage the
engine.
7.4.4 Voltage adjustment
Adjust the voltage when the engine is hot without
any applied load and the generating set is
running.
Check the voltage of the generating set using a
voltmeter via a 230 V vehicle socket. The voltage
must be between 230 V and 245 V without any
connected user.
If different values are measured, it will be
necessary to set the right values by working on
the engine rpm adjustment screw (Fig.38 Ref.1).
Turn the screw clockwise to increase the engine
rpm and consequently, the voltage.
Turn the screw counter-clockwise to decrease
the engine rpm and consequently, the voltage.
7.4.5 Adjusting the choke
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telair Energy 2510g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telair Energy 2510g in the language / languages: English as an attachment in your email.

The manual is 4,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info