688850

Telair Energy 2510g Manual

13
Zoom out
Zoom in
Previous page
1/40
Next page
Vers. 001 Energy 2510 G
13
G
B
Remember that the
pressure reducer must NOT be installed in
the body interior. Moreover, it should be
located in a well-ventilated area.
No pressure reducing device should be placed
between the Telair reducer (Fig. 15 Ref. 4) and
the gas bottle.
The gas hose (Fig. 15 Ref. 5) which directly
connects the pressure reducer and the gas bottle
(Fig. 15 Ref. 3) is not supplied.
For this connection, the installer will use a
suitable type-approved hose which is equipped
with the suitable fittings.
Connections as shown
in Fig. 16 are FORBIDDEN on both the
reducer and the gas bottle.
Fig. 17 shows proper connection, with a suitable
hose on which the fitting (6) is tightened.
Fit the ogive (7), hold the fixed hexagon ring (8)
by means of a wrench and tighten the ring nut
(9).
When using the
generator in cold environments, please
remember that the lower the temperature
(down to a temperature limit of – 15°C),
the higher the percentage of propane gas
which is recommended
4.10 Battery charger
ENERGY 2510 G generating sets are equipped
with a battery charger which can deliver current
of approximately 10 Amp at 12 V. It can be used
to recharge the generating set start-up battery.
To obtain this function, use a 2,5 mm
2
cross-
section cable to connect the terminal identified by
CHARG (Fig.19 Ref. 1) to the positive pole (red
cable) of the generating set (Fig. 19 Ref. 2)
possible to use the 12 Volt alternating current
output provided on the bipolar connector shown
in Fig. 13 Ref. 6 .
4.11 Auxiliary Battery Charger
If you wish to recharge a different battery or do
not wish to use the CHARG terminal, it is To
these two Faston terminals, 4 sq.mm cross-
section cables should be connected to obtain
interfacing to an optional RCB regulator (code
05424) as shown in Fig. 20.
The generating set will
not autonomously recharge the battery used
for starting-up unless this is connected to a
battery charger.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Telair Energy 2510g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Telair Energy 2510g in the language / languages: English as an attachment in your email.

The manual is 4,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info