781279
11
Zoom out
Zoom in
Previous page
1/31
Next page
P.20 P.21
Operate Washer Dryer Machine
Operate Washer Dryer Machine
pressed before starting the program. If the program already started, should press the
On/Off button.
Notes: If there is any break in the power supply while the machine is operating, a special
memory stores the selected programme and when the power is restarted, press the
Start/Pause button the left time is continues.
- Reload
This operation can be executed during the washing procedure. When the drum of the
washer dryer machine is still rolling and there is large amount of water with high temperature
in the drum. The state is unsafe and the door cannot be opened forcefully. To press
Start/Pausefor 3 sec. to reload, and start the clothes adding in the midway function .
Please follow the steps as bellow:
1.Wait until the drum stops rotation. 2.The door lock is unlocked.
3.Close the door when the clothes needs are loaded and repress theStart/Pausebutton.
Notes:Dont use the Reload function when the water surface over the edge of the inner tub
and the temperature is higher.
- Child Lock
To avoid that the washing procedure cannot operate normally due to the mis operation by
kids during the washing procedure, you can select this function, In this case, the other
buttons except On/Off button can not work, at this state ,the machine power off when press
the key on/off. The machine remembers the program child lock and the program during
powered off when press the key on/off again.
Press Function and Select together 3 seconds during the running procedure, the buzzer
will beep ,Start/Pause button as well as the rotary switch are locked. Press the two buttons
for 3 seconds together and buzzer will beep to release to locking. But cut off the power
supply , the kid’s protection is also release to locking. The kids protection will not be
cancelled after all procedures are completed.
- Suppression of the acoustic signals
This is an additional buzzer function on your appliance. After deactivating the buzzer
function, the buzzer will be closed.
After starting the machine, press the “Temp. and Dry” button for 3 seconds and you will
hear a beep, then the buzzer will be closed. To restart the buzzer function, press the “Temp.
and Dry” button again for 3 seconds. The setting will be kept until the next reset.
- Bubble Removal Function
Bubble Check Function: Redundant bubbles will occur when there is excessive detergent,
which will affect wash and rinse effects. The procedure will check automatically and one
bubble removal procedure will be added automatically to remove bubbles when excessive
bubbles are checked.
- Quick
This procedure is suitable for washing few and not very dirty clothes quickly.
You can select this procedure to wash your delicate clothes. Its washing intension is
gentler and revolution speed is less compared with the procedure “Synthetic. It is
recommended for the articles to be washed softly.
You can choose the program washing brightly colored clothing, it can protect the bright
colors better .
This program is specially designed for washing jeans.
So dirty clothes can choose this function.It can select the prewash function to increase the
washing effect, you need to put detergent into the Case (I) when using pre-wash function.
- Less Iron
Less Iron function can be used to reduce the wrinkles of clothes.
- Delicate
- Wool
You can select this procedure to wash the wool textiles labeled with “Machine Wash.
Please select the proper washing temperature according to the label on the articles to be
washed. Furthermore, the proper detergent shall be selected for wool textiles.
- Colors
- Jeans
- Spin Only
Separate spin only procedure. Soap water or rinse water shall be drained out before spinning.
- Rinse&Spin
Separate Rinse&Spin Procedure.
- My Cycle
Press Spin button 3sec. for my cycle to memory the procedure. The default my cycle is cotton.
The main function can be selected as follows:
- Prewash
The Prewash function can get an extra wash before main wash.
- Extra Wash
- Speed Wash
The function can decrease the washing time.
- Extra Rinse
The laundry will undergo extra rinse once after you select it.
- Delay
Delay function can be set with this button, the delaying time is 0-24 H.
Set the Delay function:
1. Select a programme;
2.Press the Delay button to choose the time;
3.Press Start/Pause to commence the delay operation.
Cancel the Delay function: Press the Delay button until the display will be 0H.It should be
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teka TKD 1610 WD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teka TKD 1610 WD in the language / languages: English, Spanish as an attachment in your email.

The manual is 12.4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info