24497
10
Zoom out
Zoom in
Previous page
1/41
Next page
18
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
min 50 cm
max 85 cm
+2,6 mt max
max 100 cm
min 4 cm
EN
Fix the sheet of corrugated
material on the bottom as
shown in picture.
Connect the fill hose
to the tap.
A-LSI2 1200:
This appliance is set to be
connected to hot and cold
water supply for improved
energy consumption.
The grey hose must be
attached to the cold
water tap and the red hose
must be attached to the hot
water tap.
The appliance must be
connected to the water
mains using new hose-sets.
The old hose-sets should not
be reused.
IMPORTANT:
DO NOT TURN THE TAP
ON AT THIS TIME.
Position the washing machine
next to the wall.Hook the
outlet tube to the edge of the
bath tub, paying attention
that there are no bends or
contractions along the tube.
It is better to connect the
discharge hose to a fixed
outlet of a diameter greater
than that of the outlet tube
and at a height of min. 50 cm.
If is necessary to use the
plastic sleeve supplied.
19
DE
Befestigen Sie die gewellte
Bodenplatte wie in der
Abbildung dargestellt.
Den Zulaufschlauch an den
Wasserhahn anschließen.
A-LSI2 1200:
Um den Stromverbrauch zu
senken, ist diese
Waschmaschine, zuzüglich
zum Kaltwasseranschluß, mit
einem Warmwasseranschluß
ausgestattet.
Der graue Schlauch ist an
den Kaltwasserhahn
anzuschließen, während der
rote Schlauch an den
Warmwasseranschluß zu
verbinden ist.
Das Gerät muß an die
Wasserversorgung mit neuen
Schläuchen angeschlossen
werden.
Alte Schläuche dürfen nicht
wiederverwendet werden.
ACHTUNG:
WASSERHAHN NOCH
NICHT ÖFFNEN.
Die Waschmaschine an die
Wand rücken,darauf achten,
daß dabei der Schlauch nicht
verkrümmt oder eingeengt
wird.
Ablaufschlauch am
Wannenrand
befestigen,oder an einem
festen Abfluß von mindestens
50 cm Höhe anbringen, dessen
Durchmesser größer ist als der
des
Waschmaschinenschlauchs.
Falls erforderlich den
mitgelieferten starren
Rohrbogen benutzen.
FR
Appliquer la feuille
supplémentaire sur le fond
comme dans la figure.
Raccorder le tube de l’eau
aux robinets.
A-LSI2 1200:
Pour l’optimisation des
consommations
énergétiques, il est possible
d’alimenter ce lave-linge
directement en eau
chaude.
Reliez:
- le tuyau gris a l’eau froide
- le tuyau rouge a l’eau
chaude.
L'appareil doit être relié à
l'arrivée d'eau exlusivement
avec les tuyaux fournis .
Ne pas réutiliser les anciens
tuyaux.
ATTENTION:
NE PAS OUVRIR LE
ROBINET
Approcher la machine
contre le mur en faisant
attention à ce que le tuyau
n’ait ni coudes ni
étranglements.
Raccorder le tuyau de
vidange au rebord de la
baignoire ou, mieux encore,
à un dispositif fixe
d’évacuation,hauteur mini.
50 cm et de diamètre
supérieur au tuyau de la
machine à laver.
En cas de besoin, utiliser le
coude rigide livré avec la
machine.
Aplique la lámina de
polionda como se muestra
en la figura.
Conecte el tubo del agua
al grifo.
A-LSI2 1200:
Esta lavadora permite ser
conectada a la red
hidráulica con agua
caliente y fría para un
mayor ahorro energético.
El tubo gris debe ser
conectado a la salida de
agua fría mientras que
el tubo rojo debe ser
conectado al del agua
caliente.
El aparato debe ser
conectado a la red
hidráulica sólo con los
nuevos tubos de carga
disponibles en dotación.
Los viejos tubos de carga no
tienen que ser reutilizados.
ATENCIÓN:
NO ABRA EL GRIFO.
Acerque la lavadora a la
pared procurando que no
se formen curvas o
estrangulamientos, fije el
tubo desagüe al borde de
la pila.
o mejor aún, a un desagüe
fijo, con un diámetro mayor
que el del tubo de la
lavadora, a una altura
mínima de 50 cm.
En caso necesario, utilice la
curva rígida adjunta.
ES PT
Fixe a placa de material
ondulado no fundo da
mãquina, da forma indicada
na figura.
Ligue a mangueira de
admissão de água à torneira
de alimentação.
A-LSI2 1200:
Este utensílio está pronto
para juntar a água quente
e fria, fornecida para
minimizar o consumo de
energia.
A mangueira cinzenta deve
ser encaixada na torneira
da água fria , e a
mangueira vermelha deve
ser encaixada na torneira
da água quente.
Os acessórios devem estar
ligados à torneira da água,
usando mangueiras novas.As
mangueiras não devem ser
reutilizadas.
ATENÇÃO:
NÃO ABRA A TORNEIRA!
Encoste a máquina à parede.
Prenda o fim da mangueira
de esgoto por cima da
borda da bacia ou do tubo
de descarga,assegurando-
-se de que não esteja
torcida ou dobrada.
Sempre que possível, utilize
um tubo de esgoto fixo com
um diâmetro superior ao da
mangueira de esgoto da
máquina de lavar, a fim de
permitir a saída do ar.
O topo da mangueira de
esgoto deverá estar a uma
altura mínima de 50 cm.
Se necessário use a curva
rígida fornecida juntamente
com a máquina.
LSI2 1200
A-LSI2 1200
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teka LSI2_1200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teka LSI2_1200 in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info