24
INSTALLATION
TECHNICAL INFORMATION
FOR THE INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
3) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials
(cardboard, bags, polystyrene foam, nails, etc.)
within children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the top of
the modular cabinet and into which the hot plate will
be installed are indicated in either fig. 7. Always
comply with the measurements given for the hole into
which the appliance will be recessed (see fig. 7 and 8)
.
The filotop model needs of a milling on the plan top
of depth 3 mm, measures are shown in figures 10/A
and 10/B of next page. It is advisable to spread on
the milled surface a layer of "primer" anti-infiltration.
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
4) FIXING THE HOT PLATE
The hot plate has a special seal (in the case of
filotop) or putty (in the case of semifilo) which
prevents liquid from getting into the cabinet.
Strictly comply with the following instructions in
order to correctly apply this seal:
- detach the seals (or putty) from their backing,
checking that the transparent protection still
adheres to the seal (or putty) itself.
- Overturn the hot plate and correctly position seal
(or putty) “E” (fig. 9) under the edge of the hot
plate itself, so that the outer side of the seal (or
putty) perfectly matches the outer edge of the
hot plate. The ends of the strips must fit together
without overlapping.
- Evenly and securely fix the seal (or putty) to the
hot plate, pressing into place with the fingers and
remove the strip of protective paper from the seal
(or putty) and set the plate into the hole made in
the cabinet.
- To insert the hooks “G” into the fissures on the
bottom and rotate them according to the arrow
indicationts. To insert the screw “F” into the bottom
holes and turn thoroughly the screws “H” on the
hooks holes (see the sequence on the next page).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the
working, is necessary to put a wooden insert,
fixed by screws, at a minimum distance of 120 mm from
the top (see fig. 7).
- To follow the installation measures shown in
figures 10/A, 10/B and 11/A, 11/B.
FIG. 7 FIG. 8 FIG. 9
COMPLY WITH THE
DIMENSIONS(in mm)
A B C D E
4F 565 495 52.5 52.5 60 min.
5F 835 495 52.5 52.5 60 min.
