Manual Teka CB380 (page 29 of 57) (English, German, French, Portuguese, Spanish)

18320

Zoom out

Zoom in

1/57

Control panel (fig. 13)

To activate the quick freezing function turn dial “A” clock-wise to the “Super” position, the

yellow LED “E” will switch on to indicate that the quick freezing process has begun. This

stage will stop automatically after 50 hours (the yellow LED will turn off). To restore the

appliance to the previous settings turn the dial “A” to the previous position, other than

“SUPER”.

Control panel (fig. 2) for Built-In Fridge Freezer with 2 compressors

To activate the quick freezing function turn dial “D” clock-wise to position “S”, and the yel-

low LED “C” will light up. After 50 hours, when the quick freezing process has finished,

the yellow light “C” will flash to indicate that the thermostat dial needs to be turned to the

normal working position.

Combi fridge freezers with or without control panel (fig. 12)

24 hours before beginning freezing, make space for the products requiring freezing.

When freezing starts, in order not to cool the refrigerator compartment excessively, it may

be necessary to decrease the setting on the thermostat dial by one or two numbers,

depending on the load and the ambient temperature. When freezing is over, reset the

thermostat at its normal dial setting.

Single compressor, built-in version with control panel (fig. 2)

In addition to the instructions for combi appliances without control panel:

for improved freezing, whenever the ambient temperature is above 30°C, it is recommen-

ded to turn the thermostat to the “S” position for rapid freezing, approximately 6 hours

before inserting fresh food for freezing.

After 6 hours (when LED “C” is flashing) turn the thermostat dial to a normal working posi-

tion different from “S”.

FOR ALL APPLIANCES, the maximum quantity that can be frozen, as laid down by

European standards, is indicated on the serial number and specification plate.

DEFROSTING

The refrigerating compartment defrosts automatically whenever the compressor is not

working. During these periods the water drops that are formed from the melting frost drain

into an appropriate container located over the compressor, which, with the heat it genera-

tes, causes it to evaporate.

It is advisable not to place either food or the container against the back panel.

For defrosting the freezer compartment, follow these instructions:

a) 24 hours before defrosting set the thermostat knob onto the high numbers or activate

fast freezing, to lower the temperature of the food.

b) Wrap frozen foods in sheets of special foodstuff paper and plate them in a refrigerator

or in a cool place.

c) Set the thermostat to "0" or, where appropriate, switch off the green switch.

d) Leave the door open.

e) When defrosting is finished, dry the inside and replace the food that had been removed.

f) Set the refrigerator to its former condition and allow it to function with the thermostat on

a high value.

Fig. 9) Important: the freezer is equipped with a frost water evacuation system consisting

of a flexible rubber drain tube located on the bottom panel of the cell.

Fig. 10) Important: in some models the defrosted water is discharged from the freezer by

means of a pipe (closed with a plug) connected to a drip located at the base.

In some models the drip tray must be pulled out from the chick plate and replaced after

defrosting (fig. 10b).

N.B.: Remember to remove the plug that closes the pipe in order to drain the defrosted

water and replace the plug after the water has been drained.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Teka CB380 in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Teka CB380 Manual

Product: