18320

Teka CB380 Manual

24
Zoom out
Zoom in
Previous page
1/57
Next page
GENERAL INFORMATION
1) Carefully read the instructions contained in this handbook since they provide important
information relative to safety during installation, use and maintenance.
Keep this handbook carefully for future reference.
2) Once the appliance has been unpacked make sure that it is undamaged.
This appliance should be used only for the purpose for which it was specifically designed,
namely for the conservation of foodstuffs.
Any other use is considered unsuitable, and thus dangerous.
The manufacturer declines all responsibility for any damage that may be caused by
unsuitable, incorrect or unreasonable use.
Send off the warranty certificate.
Declaration of compliance: the parts of this appliance that may come into contact with
foodstuffs comply with the provisions of EEC Directive 89/109.
This appliance complies with Directives 89/336/EEC, 73/23/EEC and following
changes.
HOW TO USE THE REFRIGERATOR
Electrical connection
This refrigerator is set to work at the nominal voltage indicated on the rating plate inside
the product. Voltage fluctuations should not be greater or less than 10% of the nominal
voltage.
Before connecting the appliance ensure that the data to be found on the rating plate is the
same as the mains supply. The rating plate is to be found inside the product.
In the case of incompatibility between the socket and the plug of the appliance have the
socket replaced with another, suitable one by a qualified electrician, who will also verify
that the capacity of the socket wiring is adequate for the power absorbed by the
appliance.
The use of multiple socket adapters and/or extension cables is not recommended. The
supply socket of the refrigerator must be properly earthed. This fundamental safety requi-
rement must be verified and, if there are any doubts, the installation should be thoroughly
checked by a professional electrician.
The manufacturer declines all responsibility for any damage caused by the appliance not
being earthed.
INSTALLATION
For models where the feet are not already fitted, screw these into the relative threaded
holes under the refrigerator. Ensure that the two front feet are not quite fully screwed
home, so that the refrigerator leans slightly backwards.
Where applicable, fit the appropriate spacers (fig. 1) in order to obtain proper air circula-
tion between the refrigerator and the wall behind: it is also recommended not to block any
ventilation or heat dispersal openings or grilles, leaving a space of at least 5 cm.
Do not install the refrigerator close to sources of heat. Furthermore, do not install the refri-
gerator anywhere where the temperature will be below +16°C or above +38÷43 for long
periods.
Should the cabinet be installed below a wall unit a minimum gap of a 5 cm must be left
either on the back or on the top of the unit to allow air circulation.
Incorrect installation could cause damage to people, animals or things, for which the
manufacturer declines all responsibility.
25
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teka CB380 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teka CB380 in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info