Check that all the filters are in place.
Do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and filter).
Never place the foam and microfilter in the appliance unless they are completely dry.
If you have any difficulties in finding accessories or filters for this vacuum cleaner, contact the Tefal Customer Ser-
vice.
1. Fitting the elements onto the appliance
Clip the end of the hose to the suction inlet located at the front of the appliance (fig.1). To remove, unclip the end
using the clip and remove.
Fix the accessory support to the notch in the parking position located at the back of the vaccuum cleaner (fig.2)
and store the accessories on top.
I
MPORTANT! If the accessory support* (30) is positioned at the rear of the appliance, you must remove it so
that the vacuum cleaner’s lid (1) can be opened.
• Fit the metal telescopic tube to the end of the nozzle until you hear a click indicating that it is locked (fig.3). To re-
move, press the tube lock button and remove.
• Fit the multi-surface nozzle (23) to the end of the metal telescopic tube until you hear a click indicating that it is
locked (fig.4). To remove, press the nozzle lock button and remove.
• Adjust the metal telescopic tube to the desired length using the telescopic system (fig.5).
Fit the corresponding accessory to the end of the metal telescopic tube or the nozzle:
- For rugs and carpets: use the multi-surface nozzle in the retracted brush nozzle position or the Turbo-brush*
(fibres and animal hairs).
- For smooth surfaces with crevices (such as tiled floors): use the all-surface nozzle (23) with the brush extended
or, for better results, use the smooth surface nozzle* (27B.a*) without the removable brush.
- For fragile surfaces, such as parquet, it is recommended to use the standard parquet nozzle (26* or 27A*) or the
nozzle with line of bristles (27B.b*).
- For corners and hard to reach spots: use the telescopic crevice nozzle*.
- For upholstery and delicate surfaces: use the brush with the nozzle (EASY BRUSH) or the upholstery nozzle*.
IMPORTANT: always switch off and disconnect your vacuum cleaner before changing the accessories.
ERGONOMIC RECOMMENDATIONS
ERGO COMFORT range
Ergonomic, the ERGO COMFORT range has been designed to facilitate and improve user comfort when va-
cuuming.
To prevent bending over and to ensure upright posture, make sure to:
1. Adjust the length of the ERGO COMFORT metal telescopic tube to your body (fig.6).
2. Place your second hand on the front of the ERGO COMFORT nozzle handle (fig.7).
2. Plugging in the power cord and switching on the appliance
Unwind the power cord completely, plug in your vacuum cleaner and press the ON/OFF button (fig. 8).
ATTENTION: do not operate your vacuum cleaner without the filtration system fitted (foam, microfilter and
filter).
Set the suction power using the manual power switch on the power nozzle (fig.9):
• Position (MIN) for vacuuming delicate fabrics (curtains, textiles).
• Position
(Medium) for daily vacuuming of all types of surfaces with low levels of soiling.
• Position (MAX)
for vacuuming hard floors (tiled floors, parquet, etc.) and rugs and carpets in the case of high levels of soi-
ling.
3 • Storing and transporting the appliance
After use, switch off your vacuum cleaner by pressing the ON/OFF button and unplug it (fig. 10).
Wind the power cord by pressing the power cord wind button (fig. 11).
UTILISATION
10
*According to model: these parts are specific to certain models or they are accessories that can be purchased separately.
