723224
13
Zoom out
Zoom in
Previous page
1/44
Next page
15
EN
3.2 Microfilter (12)
Open the motor protection grid (11) - fig. 33a.
Separate the microfilter * (12) from the motor protection grid (11) - fig.33b.
Discard the microfilter* (12) into a dustbin - fig. 33c and replace it with a new microfilter (ref. RS-RT900037).
Place the new microfilter * (12) on the motor protection grid (11) - fig.33d.
Place the pins of the protection grid (11) in the notches on the dust compartment housing (7) - fig. 33d.
Lock the motor protection grid (11) - fig. 33e.
Make sure the microfilter* (12) and the protective grid (11) are properly in position before closing the lid (8).
Cleaning the vacuum cleaner
Wipe the body of the vacuum cleaner and accessories with a soft damp cloth, then dry.
Wipe the lid with a dry cloth- fig. 34.
Do not use detergents or any corrosive or abrasive products.
Important: As soon as your vacuum cleaner stops performing efficiently, and before making any checks, stop
it by pressing on the On/Off pedal.
If your vacuum cleaner does not start
The appliance is not powered: make sure the appliance is properly connected.
If your vacuum cleaner has no suction
An accessory or the hose (19) is blocked: unblock the accessory or the hose (19).
Ensure that the dust compartment (13) is properly mounted and present.
The lid is not properly closed: check that the dust compartment (13) is properly in position and close the lid (8).
If your vacuum cleaner suction is not working properly or is making a whistling
noise
An accessory or the hose is partially blocked: unblock the accessory or the hose (19).
The dust compartment is full: empty it (see CLEANING AND MAINTENANCE chapter).
The filtration system is saturated: clean the HEPA filter capsule (14) (see CLEANING AND MAINTENANCE
chapter).
If the problem persists, change the filtration system (see the CLEANING AND MAINTENANCE chapter).
The electronic power regulator (3) is set at minimum: increase the power using the electronic power regulator
(unless you are cleaning fragile fabrics).
The mechanical power regulator is open: close the mechanical power regulator on the power nozzle - fig. 9.
Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).
If the lid does not close
Ensure that the dust compartment (13) is well properly positioned in the dust tray housing (7).
If the suction attachment is difficult to move
Open the mechanical power regulator on the power nozzle or decrease power - fig. 9.
Ensure that the position (brush retracted / brush out) of the suction attachment (22) corresponds to the surface
being cleaned.
If the power cord does not wind up completely
The cord slowed down as it was winding up: bring the cord back out and press the cord winder pedal (4) again.
If your vacuum cleaner stops while in operation
6. TROUBLESHOOTING
* According to model: these systems are specific to certain models or are accessories available as an option.
TE_ASPIRATEUR_COMPACTEO_ERGO_CYCLONIC_903086-01_903086 03/05/12 16:36 Page15
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tefal TW5376 - Compacteo Ergo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tefal TW5376 - Compacteo Ergo in the language / languages: English, French as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info