GB
98
Assembly (fig. 8):
• Fit the screw to the unit.
• Position the sausage funnel.
• Screw in the nut.
• Assemble the unit on the appliance.
Use:
• Prepare the sausage meat and season to taste.
• Soak the casing in water so it regains elasticity then thread it onto the tube (10).
• Put the sausage meat into the feeder tray, start up the appliance and press the
meat down using the pusher to keep it feeding towards the end of the tube.
• Stop the appliance and make a knot in the casing to seal.
• Start up again and continue pushing the sausage meat with the pusher.
“Kebbe” accessory (according to model)
Use this accessory without the grid or blade. It adapts to the grinding unit so
you can prepare mixes (e.g., lamb + bulgur wheat) in a tube shape. Cut the tubes
obtained into short sections garnished with a mixture of minced meat and pinch
the ends. Fry the meat balls obtained.
Assembly: same as with sausage funnel (fig. 9).
Biscuit maker (J) (according to model)
Assembly (fig. 10) :
• Fit the screw (6) in the grinding unit (5) of the grinding head.
• Place the mould (12b) in the support (12a) and place the assembly on the
grinding head ensuring that the lugs are aligned with the slots of the grinding
unit (5) and screw the nut (9) in fully.
• Place the head thus fitted on the motor unit (1) as shown in (fig. 10).
Use:
• Prepare the mix (you will obtain better results with a soft mix).
• Choose the shape by pointing the arrow on the chosen shape.
• Start up the appliance and supply with mix.
Juice and coulis accessory (according to model)
Use this accessory to make coulis (red fruits and tomatoes) and juices (apples,
pears, oranges, etc.). It fits to the grinding unit (5).
Assembly (fig. 10) :
• Fit the grinding unit (5) of the motor unit (1).
• Place the screw (13a) in the grinding unit (5).
Note: this accessory is
used without either grid
or blade.
