Dry ironing
• Do not press the steam control button under the iron handle.
Vertical steam ironing
• Set the iron temperature control slide and the steam output control dial (located
on the control panel) to the MAX position.
• Hang the garment on a coat hanger and hold the fabric slightly taut with one
hand.
As steam is very hot : never attempt to remove creases from a garment
while it is being worn, always hang garments on a coat hanger.
• Holding the iron in a vertical position, tilted slightly forwards, press repeatedly on
the steam control button (underneath the iron handle) moving the iron from top
to bottom – fig.9.
Turbo steam function
• Press 2 or 3 times the turbo steam button to obtain a more powerful burst of
steam (fig.10) :
- for ironing thicker fabrics,
- to eliminate creases,
-for powerful vertical steaming.
Be careful : use the turbo steam function very carefully because
of the exceptional power of steam that may cause burns.
Refilling the water tank
When the red “tank empty” indicator light turns on, there is no more steam –
fig.11. The water tank is empty.
• Unplug the generator. Open the water tank filler cover. – fig.4.
Fill the water tank up without exceeding the MAX level – fig.5.
• Close the water tank filler cover.
• Plug in the generator. Press the “restart” button on the control panel – fig.12.
to continue ironing. When the green light stops flashing, the steam is ready.
•
IIrroonn tteemmppeerraattuurree sseettttiinngg::
- Start with the fabrics to be ironed at a low temperature (•) and finish with those
which need higher temperatures (••• or Max).
- Mixed fibre fabric: set the ironing temperature to the setting for the most
delicate fabric.
- Woollen garments: press repeatedly on the steam control button – fig.8 to
obtain short bursts of steam, without placing the iron on the garment itself.
•• SStteeaamm oouuttppuutt sseettttiinngg::
- Thick fabric: increase the steam setting.
- At a low temperature : set the steam output control dial to the low position.
To prime the steam circuit,
either before using the
iron for the first time, or if
you have not used the
steam function for a few
minutes, press the
steam control button
several times in a row,
holding the iron away from
your clothes. This will enable
any cold water to be ejected
from the steam circuit.
Recommendations : for
fabrics other than linen or
cotton, hold the iron a few
centimetres from the
garment to avoid burning
the fabric.
7
GB
NOTE : continuous use of the
turbo steam function will
begin to cool the iron and
may cause water to drip from
the iron. If this occcurs, stop
using the turbo steam func-
tion and allow the iron ther-
mostat to reach temperature
again (thermostat light will
come on and go off)
before using this function
again.
