816139

Tefal GC713D OptiGrill plus Manual

42
Zoom out
Zoom in
Previous page
1/164
Next page
42
Troubleshooting guide
Problem Cause Solution
Button lit
+ Solid green indicator light
+ Button flashing
+ Button flashing
• Switching on the
appliance or starting
an automatic cooking
cycle with food between
plates and without
preheating(manual
mode is automatically
activated).
• 2 possible options:
– Choose the temperature setting by
pressing the button and then
press OK. Allow to cook, but you
must monitor the cooking (manual
mode).
– stop the appliance, remove the
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
The appliance stops during the cycle of
pre-heating or cooking. • The appliance has been
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local Tefal customer service.
Flashing white indicator light.
+ / / / button flashing
+ Dis continue bip
• Appliance failure.
• Appliance stored or
used in a room that is
too cold.
• Disconnect and reconnect your
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
The appliance no longer beeps.
After the preheating, I have put my food
on the grill but the indicator stays on
PURPLE and the cooking cycle does
not start.
• Your food is thicker than
4 cm. • Food must not be thicker than 4 cm.
• You have not completely
opened the grill to place
the food.
• Completely open the grill then close it.
• Not sensing the food.
The food thickness too
thin, "OK" is flashing.
• Confirm the start of the cooking by
pressing the button.
The appliance will activate in manual
mode
+ The indicator light will blink red.
• Preheating time was cut
short. • Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the
grill, select the new cooking programme
you wish to use and wait for the
preheating cycle to finish.
Flashing white
+ button flashing
+ Continuous bip
• Appliance failure • Unplug the product and contact your
customer service.
Tip, especially for meat: the cooking results on the preset programs may vary depending on origin, cut and quality of
the food being cooked, the programs have been set and tested for good quality food.
Similarly, the thickness of the meat has to be taken into account during cooking; you cannot cook food that is thicker
than 4 cm.
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tefal GC713D OptiGrill plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tefal GC713D OptiGrill plus in the language / languages: All languages as an attachment in your email.

The manual is 47.8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info