4277
25
Zoom out
Zoom in
Previous page
1/36
Next page
5- USING YOUR STEAM GENERATOR
1. Place the iron's thermostat control to the type of fabric to be ironed
.
2. The thermostat light comes on.
Be careful ! The steam generator is ready when the thermostat light goes out and when
the green “steam ready” light stays on.
Note : it is normal for the steam cord to become warm during use.
3. Adjust the steam output control dial located on the control panel .
4. To obtain steam, press on the steam control button beneath the iron handle and keep it pressed .
The steam will stop when you release the button.
8
7
6
Linen
Cotton
Wool
Silk, Viscose
Synthetics,
Polyester,Acetate,
Acrylic, Polyamide
l
i
n
l
i
n
e
n
l
a
i
n
e
w
o
o
l
s
o
i
e
s
i
l
k
s
y
n
t
h
s
y
n
t
h
c
o
t
o
n
c
o
t
t
o
n
min.
max.
4- OPERATING THE CONTROL PANEL
• Flashing green light : the water is heating up in the boiler.
• Continuous green light : steam is ready for use.
• Continuous red light : the water tank is empty.
“Restart” button : boiler reset button to be activated after each refill (see chapter 6)
Recommendations :
To prime the steam circuit, either before using the iron for the first time, or if you have not used the
steam function for a few minutes, press the steam control button several times in a row, holding the
iron away from your clothes.
This will enable any cold water to be removed from the steam circuit
Iron thermostat control setting
:
• Start with the fabrics to be ironed at a low temperature () and finish with those which need higher
temperatures (●●● or Max).
- Mixed fibre fabrics : set the ironing temperature to the setting for the most delicate fabric.
- Woollen garments : press repeatedly on the steam control button to obtain short bursts of steam,
without placing the iron on the garment itself.
Steam output control dial setting :
- Thick fabric : increase the steam setting.
- At a low temperature : set the steam output control dial to the low position.
T
o iron without using steam :
• Do not press on the steam control button under the iron handle.
Ironing Boar
d :
For best results, a mesh type ironing board should be used to allow any excess steam to escape.
• If you are using starch, it should be sprayed onto the reverse side of the fabric to be ironed.
l
i
n
l
i
n
e
n
l
a
i
n
e
w
o
o
l
s
o
i
e
s
i
l
k
s
y
n
t
h
s
y
n
t
h
c
o
t
o
n
c
o
t
t
o
n
min.
max.
6
8
7
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tefal 2930 Pro Express (1 KB) at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tefal 2930 Pro Express (1 KB) in the language / languages: Dutch as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info