636951
17
Zoom out
Zoom in
Previous page
1/26
Next page
16
GENERAL MAINTENANCE
AFTER EACH WASH
After every wash, turn off the water supply
to the dishwasher and leave the door
slightly open so that moisture and odours
are not trapped inside.
REMOVE THE PLUG
Before cleaning or performing
maintenance, always remove the power
plug from the mains wall socket.
NO SOLVENTS OR ABRASIVE CLEANERS
To clean the exterior and rubber parts of the
dishwasher, do not use solvents or abrasive
cleaning products. Only use a cloth with
warm soapy water. To remove spots or
stains from the surface of the interior, use a
damp cloth with water and a little
vinegar, or a cleaning product made
speci cally for dishwashers.
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is
equipped with water supply and drain hoses that can be positioned either to the right or
the left sides to facilitate proper installation.
Refer to the rating label for the rated voltage and connect the dishwasher to the
appropriate power supply. Use the required 10 amp fuse, time delay fuse or circuit
breaker recommended and provide separate circuit serving only this appliance.
For your own safety:
• DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG
WITH THIS DISHWASHER.
• DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
EARTHING CONNECTION FROM THE POWER CORD
• DO NOT TAMPER WITH THE POWER CORD. IF THE CORD
REQUIRES REPLACEMENT, PLEASE CONTACT TECO SERVICE.
LEVELLING THE DISHWASHER
Once the appliance is positioned for levelling, the height of the
dishwasher may be altered via adjustment of the screwing level of
the feet. In any case, the appliance should not be inclined more
than 2.
WHEN NOT USED FOR LONG PERIODS
It is recommended that you run a wash
cycle with the dishwasher empty and then
remove the power plug from the socket,
turn off the water supply and leave the door
of the appliance slightly open. This will help
the door seals to last longer and prevent
odours from forming within the dishwasher.
MOVING THE DISHWASHER
If the dishwasher must be moved, try to
keep it in the vertical position. If absolutely
necessary, it can be positioned on its back.
SEALS
One of the factors that cause odours to
form in the dishwasher, is food that remain
trapped in the seals.
Periodic cleaning with a damp sponge will
prevent this from occurring.
Fig.17
POSITIONING THE DISHWASHER
POWER CONNECTION
INSTALLATION
WARNING
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Teco TDW12SA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Teco TDW12SA in the language / languages: English as an attachment in your email.

The manual is 3,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info