486783
30
Zoom out
Zoom in
Previous page
1/42
Next page
www.technomate.com
5756
Your Digital Partner for Life
1) Check if the scart is connected,
2) Check the A/V settings on your television is correct,
3) Scart cable could be faulty there fore replace of in doubt.
The receiver is on but I cannot get any Menu on the screen?
1) Check if the LNB cable is inserted into the IF INPUT,
2) Check if the LNB setup menu is correctly set.
3) Your satellite Dish may be out of alignment or your LNB may be is faulty.
4) Go to Easy installatin guide and start fresh,
5) Contact your dealer / installer.
I get the message ‘no signal’ displayed?
You need to check the following :
1) Check if you a correct transponder.
Go to advance search, Turn on the Network Search, press red
button to tune.
2) Make sure you have correct PID numbers.
b) if above dose not help go to
www.lyngsat.com
www.kingofsat.net/en/prefs.php
Please contact your Supplier for further assistance.
I cannot access a particular channel I require?
Press Menu on the remote, Go to system information press ok, Full
information is displayed.
How can I find out what software version I have?
For security reason, please contact your dealer.
I have lost my personal Lock Code setting, what do I do?
IEC 169-24, female
950MHz ~ 2150MHz
-65dBm ~ -25dBm
DC 13/18V, max 400mA
22KHz
Ver 1.0/1.1/1.2/USALS Compatible
DVB-S/S2 QPSK, 8PSK
DVB-S : 2~45Msps
DVB-S2 : 10~30Msps(QPSK) 10~30Msps(8PSK)
Auto conversion
IEC 169-2, Female
IEC 169-2, Male
149 ~ 426 MHz, 434 ~ 858 MHz
75 Ohms Nominal
7,8MHz(-78dBm~-25dBm) switchable by software
7,8MHz
OFDM(DVB-T, DVB-T2)
DVB-T : 2k, 8k / DVB-T2 : 1k, 2k, 4k, 8k, 16k, 32k
DVB-T : 1/2, 2/3, 3/4, 5/6, 7/8
DVB-T2 : 1/2, 3/5, 2/3, 3/4, 4/5, 5/6
DVB-T : 1/4, 1/8, 1/16, 1/32
DVB-T2 : 1/4, 5/32, 1/8, 5/64, 1/16, 1/32, 1/64, 1/128
32bit processor (450MHz)
128Mbyte X 2
8Mbyte
256Kbit
MPEG-2, MPEG-4, H.264
up to 15M bits/s
1920 X 1080p/i, 1280 X 720p, 720 X 576p/i
PAL
4:3,16:9
Mono, Stereo, Joint Stereo
32, 44.1 and 48 KHz
9pin D-sub male, Max 115K bps
Fully DVB compliant
Connector
Frequency range
Signal level
LNB supply
LNB switch control
DiSEqC
Front end
Symbol rate
SCPC and MCPC Capable
Spectral inversion
Input connector
Loop-through out
Frequency range
Input impedance
Signal level
IF Bandwidth
Waveform
Carrier Mode
Code Rate
Guard Interval
Processor
DDR SDRAM
FLASH
EEPROM
MPEG 2
Data Rate
Resolution
Video format
Aspec Ratio
DVB compliant
MPEG 1 layer 1 &2
Type
Sampling rates
Connector
System capabilities
satellite
LNB/Tuner input
Demodulator
TERRESTRIAL
System capabilities
Tuner
& Channel Decoder
System resource
Video decoder
Teletext
MPEG Audio
Serial data interface
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technomate TM-7102 HD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technomate TM-7102 HD in the language / languages: English, French as an attachment in your email.

The manual is 2,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info