645598
165
Zoom out
Zoom in
Previous page
1/184
Next page
RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 10.5
4. Check the state of wear of the motor roller. Replace if it shows evident signs of wear.
10.3.6. CHECKING THE WEAR OF THE REAR ROLLER
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
3. Check the state of wear of the rear roller. Replace if it shows evident signs of wear.
10.3.7. CHECKING THE WEAR OF THE RUBBER HANDLEBAR COVERS
1. Check the state of wear of the rubber covering on the 2 side handlebars and on the center
handlebar. Replace if they show evident signs of wear.
10.3.8. CHECKING THE TREAD BELT MOTOR DRIVE-BELT
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Check the state of wear of the tread motor drive-belt, turning it by hand using the motor
flywheel. Replace if it shows evident signs of wear.
5. Check the tension of the motor drive-belt. Adjust the tension if necessary.
10.3.9. CHECKING THE UP-DOWN MOTOR DRIVE-BELT
1. With the machine powered-up, raise it to its maximum incline (25%).
2. Turn off the machine by placing the switch in the 0 position (OFF).
3. Unplug the mains lead from the wall outlet.
4. Remove the guard plate of the up-down motor drive-belt.
5. Check the state of wear of the up-down motor drive-belt. Replace if it shows evident signs of
wear.
6. Check the tension of the up-down motor drive-belt. Adjust the tension if necessary.
10.3.10. CHECKING THE SHOCK ABSORBERS
1. Only after having worked on the tread belt and/or running track, check the condition of the
shock absorbers on either side of the running track. Replace if they are cracked or show signs of
breakage.
10.3.11. CHECKING THE SPEED CALIBRATION
1. Open the motor guard.
2. Check that when the machine runs at a speed of 12.6 km/h the inverter displays a working
frequency of 50 Hz.
WARNING: this must be done with the machine opened and powered up.
10.3.12. CHECKING THE OPERATION OF THE CARDIO RECEIVER
1. Using a separate heart rate monitor, put on the transmitter strap and check that the machine and
the separate monitor both measure the same heart rate, and that when the strap is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects the variations in the heart
rate.
Downloaded from www.Manualslib.com manuals search engine
165


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technogym Runrace at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technogym Runrace in the language / languages: English as an attachment in your email.

The manual is 9,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info