645598

Technogym Runrace Manual

162
Zoom out
Zoom in
Previous page
1/184
Next page
RUNRACE : Service & Maintenance Manual - rev. 2.0
Page 10.2
10.2. ROUTINE MAINTENANCE OPERATIONS
These operations can be carried out by the owner of the machine and do not require any
special skills.
The routine maintenance operations involve simple cleaning, lubrication and checking the state of
wear and emergency operation, in order to ensure the correct and safe operation of the machine. It is
recommended to perform these operations at least once a month.
For the routine maintenance of the machine, proceed as follows:
10.2.1. INTERNAL CLEANING OPERATIONS
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Use a vacuum cleaner to clean the interior, paying particular attention to the tread belt motor, the
inverter and the electronic circuit boards.
WARNING: when carrying out these operations, be careful not to damage the cables.
5. Pull out the dust filter and clean it using compressed air or a vacuum cleaner.
6. Move the machine and clean the floor underneath using a vacuum cleaner.
10.2.2. LUBRICATING THE TREAD BELT
1. With the machine powered up but stopped, clean the entire surface between the tread belt and
the running track using a cloth. Repeat several times if necessary.
2. Then lubricate the entire length of the running track and tread belt using Silube spray oil (code
0V022): start the machine at a speed of approximately 3 km/h (2 mph) and walk on it, taking
care to tread on the entire width of the belt, so as to facilitate the distribution of the oil on the
entire surface of the belt.
10.2.3. LUBRICATING THE ELEVATION BARS
1. With the machine powered up, raise it to its maximum elevation (25%).
2. Turn off the machine by placing the switch in the 0 position (OFF).
3. Thoroughly clean the elevation bars with a cloth and then lubricate them over their full length
with Molykote GN grease (code 0V014).
4. Turn on the machine by placing the switch in the 1 position (ON).
5. Start the machine again, going through a few complete up and down movements of the elevation
bars.
6. Check the elevation bars, adding more grease if necessary.
10.2.4. CHECKING THE STATE OF WEAR
1. With the machine stopped, check the state of wear of the entire surface of the tread belt, turning
it by hand. If any anomalies are found, call in the authorized Technogym Technical Service.
2. Check the state of wear of the running track by lifting the tread belt in the middle. If any
anomalies are found, call in the authorized Technogym Technical Service.
Downloaded from www.Manualslib.com manuals search engine
… 162 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technogym Runrace at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technogym Runrace in the language / languages: English as an attachment in your email.

The manual is 9,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info