• Remote transmission of outdoor temperature to weather station by 433 MHz signal
• Wall mounting case
• Mounting at a sheltered place. Avoid direct rain and sunshine
SETTING UP:
1. First, insert the batteries into the Weather station (see “How to install and replace batteries in the
Weather Station” below). Once the batteries are in place, all segments of the LCD will light up briefly.
Following some test data display, the indoor temperature and humidity, the time as 0:00 the date as
1.1. and the weather icons sun and clouds will be displayed. If the indoor temperature and humidity
are not displayed after 30 seconds, remove the batteries and wait for at least 10 seconds before
reinserting them. Once the indoor data is displayed proceed to step 2.
2. Within 3 minutes of activating the Weather station, place the batteries into the transmitter (see “How
to install and replace batteries in the Temperature Transmitter” below).
3. After a few seconds of inserting the batteries into the transmitter, the Weather Station will start
receiving data from the transmitter. The remote temperature will then be displayed on the Weather
Station. If this does not happen after 15 minutes, the batteries will need to be removed from both
units and reset from step 1.
4. The Weather Station can take up to 3 remote transmitters. If you have purchased additional
transmitters, follow step 2 for all extra transmitters. However, ensure that you leave 10 seconds in
between the reception of the last transmitter and the set-up of the following transmitter. The Weather
Station will number the transmitters in the order of set-up, i.e. the first transmitter will have the
temperature displayed with the number 1 against it and so on.
5. When all the transmitters are set up, there is a testing period, during which the display switches
quickly between all the received transmitters at random, according to which random transmission it
receives. Pressing any key will stop this process. The process also stops automatically if no keys are
pressed for a few minutes.
6. Once the remote temperature has been received and is displayed on the Weather Station, the DCF-
77 time code reception is automatically started. This takes typically between 3 - 5 minutes in good
27
