542295
10
Zoom out
Zoom in
Previous page
1/26
Next page
10
Follow the on-screen instructions when downloading the PC
software.
4. Radio transmission of programming settings
So that the USB programming stick can send data to
system components such as radio energy-saving
controllers or wall thermostats, these components must first
of all be set to teach-in mode.
The USB programming stick must be plugged into the
PC’s USB port.
The PC software must be running on the PC and
programming must be complete.
For transmission, the receiver (a wall thermostat, for
example) must be set to teach-in mode. For more
information on this, refer to the operating manual for the
relevant device.
The USB programming stick can now send data to the
devices that are ready to receive. To start the
transmission process, activate the transmission function
in the PC software.
The USB programming stick does not remain permanently
taught–in on the devices to be programmed.
If the USB programming stick is being used to send
a weekly programme, all devices that are ready to
receive will receive the programme accordingly. An
unlimited number of receivers can be programmed.
When being put into operation for the first time, a
radio energy-saving controller can be switched to
teach-in mode immediately after data entry (please
see the corresponding operating manual for detailed
instructions). If a wireless signal is received from the USB
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Techno line TM 3098-RF - USB-Stick at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Techno line TM 3098-RF - USB-Stick in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info