568011
230
Zoom out
Zoom in
Previous page
1/236
Next page
Fehler Mögliche Ursache Abhilfe
Gerät lässt sich nicht
bedienen, nicht ein- oder
ausschalten
Defekter Datenstrom -->
Gerät blockiert
Ein/Standby-Taste am Gerät
oder auf der Fernbedienung
für ca. 5 Sekunden gedrückt
halten.
Netzstecker für
ca. 5 Sekunden ziehen,
anschließend Gerät wieder
einschalten
Flash-Reset durchführen:
Achtung!
Dabei gehen alle
persönlichen Einstellungen
verloren.
> Netztecker aus dem
Gerät entfernen
> Standby- und
Pfeiltaste auf am
Gerät gleichzeitig
drücken und gedrückt
halten.
> Bei gedrückter
Standby- und
Pfeiltaste auf den
Netzstecker wieder
stecken
> Tasten ca. 5 Sek.
gedrückt halten und
dann beide Tasten
loslassen. Im Display
erscheint die Anzeige
Werkseinstellung”.
USB-Gerät wird nicht
erkannt
USB-Gerät ist im falschen
Dateisystem formatiert
USB-Gerät im Dateisystem
FAT32 formatieren
Gerät schaltet sich selbst-
ständig nach einer gewissen
Zeit ab
Auto Standby-Funktion ist
eingeschaltet
Auto Standby-Einstellung
prüfen und ggf. abschalten.
(siehe Punkt 8.2.7)
230
230


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technisat TechniCorder ISIO STC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technisat TechniCorder ISIO STC in the language / languages: German as an attachment in your email.

The manual is 6,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Technisat TechniCorder ISIO STC

Technisat TechniCorder ISIO STC User Manual - English - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info