568008
41
Zoom out
Zoom in
Previous page
1/48
Next page
41
Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost.
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key on the device
at the same time.
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for approx.
5 sec. then release.
Factory setting"
appears in the display.
USB device not recognised USB device formatted for
wrong file system
Format USB device for
FAT32 file format
Device automatically
switches off after a certain
time
Auto Standby function
enabled
Check Auto Standby setting
and disable if necessary.
(see section 7.2.7)
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technisat DIGIT ISIO S2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technisat DIGIT ISIO S2 in the language / languages: English as an attachment in your email.

The manual is 1,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Technisat DIGIT ISIO S2

Technisat DIGIT ISIO S2 User Manual - German - 221 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info