622382
25
Zoom out
Zoom in
Previous page
1/36
Next page
25
You can automatically link this unit with the SU-C700 and
operate them easily with the remote control.
Preparation
1 Connect this unit and the SU-C700 with a system
connection cable and a coaxial digital cable. (> 9)
2 Set the power switch lever of this unit and the SU-C700
to the [Í/I] position.
Switching this unit and the SU-C700 to
on/standby simultaneously
If you point the remote control at this unit and press
[NWP Í] when this unit and the SU-C700 are in standby
mode, this unit and the SU-C700 will be turned on
simultaneously.
When both this unit and the SU-C700 are turned on and
the input source of the SU-C700 is set to “COAX1”, you
can set them to automatically enter standby mode using
the sleep-timer. (> 23)
Switching the SU-C700’s input source
automatically
When you perform an operation such as playback on this
unit, the input source of the SU-C700 will be automatically
switched to “COAX1”.
Adjusting Bass/Middle/Treble
You can adjust the tone of the SU-C700 with this unit. Each
tonal range (Bass/Middle/Treble) can be adjusted.
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select “SETUP” and then
press [OK].
4 Press [3, 4] repeatedly to select “Tone Control” and
then press [OK].
5 Press [3, 4] to select “On (adjustment)” and then press
[OK].
6 Press [3, 4] to select “BASS” (Bass), “MID” (Middle) or
“TREBLE” (Treble).
7 Press [2, 1] to adjust the level and then press [OK].
Each level can be adjusted between “s10” and “r10”.
For information on the operations of the SU-C700, please also
refer to its operating instructions.
Troubleshooting
Before requesting service, make the following checks. If you
are uncertain about some of the check points, or if the
solutions indicated in the following guide does not resolve
the issue, then consult your dealer for instructions.
Heat buildup of this unit.
This unit becomes warm when used for a long time. This is
not a malfunction.
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s firmware to
ensure that our customers are enjoying the latest
technology. (> 24)
A “humming” sound can be heard during
playback.
An AC mains lead or fluorescent light is near the cables.
Keep other appliances and cords away from the cables of
this unit.
No sound.
Check the volume of the connected device (amplifier, etc.).
Check to see if the cable connections to the input and
output terminals are incorrect. If this is the case, turn off
this unit and reconnect the cables correctly.
Check to see if the correct input source is selected.
Insert the plugs of the cables to be connected all the way
in.
When “Digital Output” and “Analog Output” are set to “Off”,
no sound will be output. Change the setting of the output
terminal to be used to “On”. (> 22)
Playback of multi-channel content is not supported.
Using the system control
function
To return all settings to the factory defaults
When the following situations occur, reset the memory:
There is no response when buttons are pressed.
You want to clear and reset the memory contents.
1 Press [NWP].
2 Press [HOME].
3 Press [3, 4] repeatedly to select “SETUP” and then
press [OK].
4 Press [3, 4] repeatedly to select “Initialization” and
then press [OK].
5 Press [3, 4] to select “Yes” and then press [OK].
6 Press [3, 4] to select “Yes” and then press [OK]
again.
General
ST-C700-SQT0492_EBGN_mst.book 25 ページ 2015年6月15日 月曜日 午前9時16分
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics ST-C700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics ST-C700 in the language / languages: English as an attachment in your email.

The manual is 1,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Technics ST-C700

Technics ST-C700 User Manual - German, Dutch - 124 pages

Technics ST-C700 User Manual - Danish - 124 pages

Technics ST-C700 User Manual - French, Italian - 124 pages

Technics ST-C700 User Manual - Polish - 36 pages

Technics ST-C700 User Manual - Swedish, Spanish, Finnish - 124 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info