637112
57
Zoom out
Zoom in
Previous page
1/60
Next page
Maintenance of external surfaces
To clean this unit, use a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a
soap-and-water solution or a weak detergent solution.
Wring the cloth well before wiping the unit.
Wipe once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzene, or chemically treated
cloths to clean this unit. Such chemicals may damage the finish of
your system.
Tape head care
To assure sound quality for recording and playback, be sure to clean
the tape heads after approximately every 10 hours of use.
1. Press POWER on the amplifier to ON.
2. Press _ OPEN to open the cassette holder.
3. Press POWER on the amplifier and CLOSE at
the same time.
The system will go into power standby mode leaving the cas-
sette holder open.
4. Clean the tape heads, pinch rollers and the cap-
stan shafts with a cotton swab (or a soft, lint-
free cloth) slightly moistened with isopropyl
alcohol.
Do not use any solution other than alcohol for head cleaning.
08
Pinch roller --_
)stan
Head
Ca
Cotton swab
Pinch roller
)stan
i_iiiiiiiii@
Selection of cassette tapes
You can use normal, chrome, and metal tapes for recording:
oThe deck automatically identifies the kind of tape loaded, and sets
the bias (for recording) and equalization accordingly.
oThe deck automatically sets the recording level.
Cassette tapes exceeding 90 minutes:
These tapes are handy for their long playback and recording time but
be careful about repeatedly stopping and starting, rewinding and fast
forwarding these tapes in short intervals as they are thin, tend to
stretch and may become entangled in the deck mechanism.
Do not use the Fe-Cr tapes (TYPE lll) in this system:
If you use this tape, it is impossible to obtain the required flat
frequency response.
If the tape loosens, take up the slack
Tape slack may cause the tape to break.
@
To prevent erasure of recorded sounds
Remove the erase-prevention tabs with a screwdriver or a similar
object.
Side A
Tab for side B Tab for side A
To re-record on a protected cassette, cover the slot with adhesive
tape.
Detection hole _/Adhesive
tape
Do not cover the detection holes on chrome and metal tapes.
Improper tape storage:
You can damage tapes if you store them in the following places:
din high temperature [35°C (95°F) or higher] or high humidity (80%
or higher) areas
din a strong magnetic field (near a speaker, on top of a TV, etc.)
This can erase a recording.
oAreas exposed to direct sunlight
57
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SC-CH717 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SC-CH717 in the language / languages: English as an attachment in your email.

The manual is 6,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info