637111
58
Zoom out
Zoom in
Previous page
1/60
Next page
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
I Problem Probable cause(s) t Suggested remedy I
Problems common to all systems
There is no sound when the Volume is set too low. Adjust the volume level with the volume control on
power is ON. the amplifier.
The location of the various The (+) and (-) connections to one of the Connect the speaker cords correctly.
musical instruments is not speakers are reversed.
well defined.
The left and right sounds The left and right connections to the speaker are Connect the speaker cords correctly.
are reversed, reversed.
When listening to the The left and right connections to the external unit Connect the external unit's cord correctly.
external unit, the left and are reversed.
right sounds are reversed.
Only one speaker is One of the wires of the speaker cord is Connect the speaker cord correctly.
emitting sound, disconnected.
The balance control is set to left or right. Set the balance to the center position.
There is no sound when a The (+) and (-) wire of the speaker cords are Switch the system to the standby mode, and
source is being played, shorted, reconnect the speaker cords so that they are not
shorted. Then switch on the power.
"UTO" display appears on Flat cables are not connected steadily. Connect the flat cables steadily.
the compact disc changer
or tunerlsound processor
display.
While listening to FM broadcasts
The transmitting station is a long distance away.There is a "rushing noise"
during a stereo broadcast
which is not audible during
a monaural broadcast.
You hear excessive noise
during a stereo broadcast,
and occasionally the sound
disappears.
The stereo indicator
flickers and does not light
completely.
The sound during a stereo
broadcast is highly
distored.
The installation location and orientation of the
antenna are unsuitable.
The transmitting station is a long distance away.
The power of the TV set or VCR is ON.
There is a building or mountain nearby. [Distortion
is caused by interference between the signal from
the transmitting station (direct wave) and the
signal reflected from the building or mountain
(reflected wave).]
elf you are using an indoor antenna, change to an
outdoor antena.
elf you are using a high-grade outdoor antenna, try
changing the installation location, height and
orientation.
Try switching off the TV set or VCR.
Use a high-grade outdoor antenna, and install it in a
good location, height and orientation for reception.
While listening to AM broadcasts
You hear an unusual beat You are using the system at the same time you Switch off the TV set, or use the system farther away
sound, are playing a TV set. from it.
You hear a low-frequency The antenna wire is near the power cord. Separate the antenna wire from the power cord.
hum.
58
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SC-CH515 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SC-CH515 in the language / languages: English as an attachment in your email.

The manual is 6,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info