612609
8
Zoom out
Zoom in
Previous page
1/24
Next page
ENGLISH
ESPAÑOL FRAN
ÇAIS
SVENSKA
8
RQT5060
Notes
Speaker impedance and allowed input
Impedance 6 6 6
Input power 100 W (DIN) 80 W (DIN) 70 W (DIN)
CAUTION
The only receivers or amplifiers you should connect to these speakers
are those whose rated output does not exceed the above figures.
Using a receiver or amp with higher ratings than listed above can
cause abnormal sounds to occur because of excessive input, damage
to the receiver or speakers, and fire. If equipment is damaged in any
way or unexpected trouble occurs during playback, unplug the system
from its outlet and call a serviceman for help.
Notes with regard to excessive input
Be sure to reduce the volume on the receiver (or amplifier) when the
signal input exceeds the rated allowable input to avoid damage to
circuitry or other malfunctions.
Other notes
Do not attach these speakers to walls or ceilings.
Do not touch the diaphragms.
To do so might cause distortion.
Keep magnetized items away
Magnetized cards, bank cards, commuter passes, etc., can be
damaged if allowed too near speaker magnets. Clocks may also be
effected.
Protection circuitry
This unit incorporates speaker protection circuitry to protect the
speaker from damage caused by excessive input or abnormal
signals; when excess input is detected, input is automatically
interrupted.
If sound is interrupted...
1. Reduce the volume of the receiver (or amplifier).
2. Check the sound source and connections for any problems.
If there is no problem, the protection circuitry will reset in a few
minutes.
After the protection circuit is reset...
Take care not to increase the receivers volume too high.
Maintenance
To clean this unit, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft cloth dipped in a soap-
and-water solution or a weak detergent solution.
Never use alcohol, paint thinner, or benzine to clean this unit.
Before using chemically treated cloth, read the instructions that came
with the cloth carefully.
Notas
Impedancia del altavoz y potencia de entrada
permitida
Impedancía6 6 6
Potencia de
100 W (DIN) 80 W (DIN) 70 W (DIN)
entrada
ADVERTENCIA
Los únicos receptores o amplificadores que Ud. deberá conectar a
estos altavoces son aquellos cuya salida nominal no exceda las cifras
de arriba.
Al usar un receptor o un amplificador con características nominales
superiores a las indicadas arriba se pueden producir ruidos anormales
debido a la entrada excesiva, el receptor o los altavoces se pueden
estropear, y además se puede producir un incendio. Si el equipo es
dañado de alguna manera o un problema inesperado ocurre durante
la reproducción, desenchufe el sistema y llame a su distribuidor para
que envíen una persona que le ayude.
Notas con respecto a una entrada excesiva
Asegurarse de reducir el volumen del receptor (o amplificador) cuando
la señal de entrada exceda la entrada nominal permitida para evitar
dañar la circuitería u otras fallas.
Otras notas
No ponga estos altavoces en paredes ni en techos.
No tocar los diafragmas, de lo contrario se ocasionarán distorsiones.
Alejamiento de objetos magnetizados
Las tarjetas magnetizadas, las tarjetas de bancos, los pases de
viajeros, etc., pueden estropearse si se dejan demasiado cerca de
los imanes de los altavoces. Los relojes también pueden ser afectados.
Circuitería de protección
Este aparato incorpora una circuitería de protección de altavoces para
proteger el altavoz de daños causados por una entrada excesiva o
señales anormales; cuando una entrada excesiva es detectada, la
entrada es automáticamente interrumpida.
Si el sonido se interrumpe...
1. Reducir el volumen del receptor (o amplificador).
2. Verificar si hay problemas en la fuente de sonido y las conexiones.
Si no hay problemas, la circuitería de protección se reajustará en
unos pocos minutos.
Después de que el circuito de protección sea reajustado...
Cuidarse de no incrementar demasiado el volumen del receptor.
Mantenimiento
Utilizar un paño suave y seco para limplar este aparato.
Si las superficies están extremadamente sucias, utilizar un paño suave
humedecido en una solución de agua y jabón o en una solución de
detergente suave.
Para limpiar este aparato no utilizar nunca alcohol, diluyente de
pintura o bencina.
Antes de utilizar un paño impregnado químicamente, leer con
atención las instrucciones suministradas con él.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SBM300M2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SBM300M2 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info