612608
8
Zoom out
Zoom in
Previous page
1/20
Next page
ENGLISHESPAÑOL
RQT5893
8
Notes
Speaker impedance and allowed
input
Impedance 6
Input power 100 W (DIN)
CAUTION
The only receivers or amplifiers you should connect to these speakers
are those whose rated output does not exceed the above figures.
Using a receiver or amplifier with higher ratings than listed above can
cause abnormal sounds to occur because of excessive input, damage
to the receiver or speakers, and fire. If equipment is damaged in any
way or unexpected trouble occurs during playback, unplug the system
from its outlet and call a serviceman for help.
Protection circuitry
These units incorporate protection circuitry to protect them from
damage caused by excessive input or abnormal signals; when excess
input is detected, input is automatically interrupted.
If sound is interrupted...
1. Reduce the volume of the receiver (or amplifier).
2. Check the sound source and connections for any problems.
If there is no problem, the protection circuitry will reset in a few
minutes.
After the protection circuit is reset...
Take care not to increase the receivers volume too high.
Excessive input
Do not play distorted sound at high levels for extended
periods.
Speakers can be damaged and their useful life reduced if sound is
played at high levels over extended periods, even when their protection
circuitry is not triggered.
Reduce the volume in the following cases to avoid damage
When operating the tone controls or equalizer on the amplifier.
When turning the amplifier on or off.
When playing distored sound.
When the speakers are receiving the following types of signals:
-Noise from FM broadcasts
-Howling from a microphone or record player
-Fast-forwarding or rewinding noise from a cassette deck
-Continuous signals from an oscillator, electronic instrument, or test
disc
Other notes
If irregular coloring occurs on your television
These speakers are designed to be used close to a television, but the
picture may be affected with some televisions and set-up combinations.
If this occurs, turn the television off for about 30 minutes.
The televisions demagnetizing function should correct the problem. If
it persists, move the speakers further away from the television.
Do not touch the diaphragms.
Doing so might cause distortion.
Keep magnetized items away
Magnetized cards, bank cards, commuter passes, etc., can be
damaged if allowed too near speaker magnets. Clocks may also be
affected.
Avoid locations such as described below.
In direct sunlight
Near heating appliances or other sources of heat
Where the humidity is high
Notas
Impedancia del altavoz y potencia
de entrada
Impedancia 6
Potencia de entrada 100 W (DIN)
PRECAUCIÓN
Los únicos receptores o amplificadores que Ud. deberá conectar a estos
altavoces son aquellos cuya salida nominal no exceda las cifras de arriba.
Al usar un receptor o un amplificador con características nominales
superiores a las indicadas arriba se pueden producir ruidos anormales
debido a la entrada excesiva, el receptor o los altavoces se pueden
estropear, y además se puede producir un incendio. Si el equipo es
dañado de alguna manera o un problema inesperado ocurre durante
la reproducción, desenchufe el sistema y llame a su distribuidor para
que envíen una persona que le ayude.
Circuitería de protección
Estos aparatos incorporan una circuitería de protección para
protegerlos de daños causados por una entrada excesiva o señales
anormales; cuando una entrada excesiva es detectada, la entrada es
automáticamente interrumpida.
Si el sonido se interrumpe...
1. Reduzca el volumen del receptor (o amplificador).
2. Verifique si hay problemas en la fuente de sonido y las conexiones.
Si no hay problemas, la circuitería de protección se reajustará en
unos pocos minutos.
Después de que el circuito de protección sea reajustado...
Cuídese de no incrementar demasiado el volumen del receptor.
Entrada excesiva
No reproduzca sonido distorsionado con niveles altos
durante largos periodos de tiempo.
Los altavoces pueden estropearse y su vida útil reducirse si el sonido
se reproduce a niveles altos durante mucho tiempo, aunque no se
active el circuito de protección.
Reduzca el volumen en los casos siguientes para evitar
daños.
Cuando opere los controles de tono o el ecualizador del amplificador.
Cuando encienda o apague el amplificador.
Cuando reproduzca sonido distorsionado.
Cuando los altavoces estén recibiendo los tipos de señales siguientes:
-Ruido de emisiones de FM
-Aullido de un micrófono o de un giradiscos
-Ruido de avance rápido o rebobinado de una platina de casete
-Señales continuas de un oscilador, instrumentos electrónico o disco
de prueba.
Otras notas
Si se producen colores irregulares en su televisor
Estos altavoces han sido diseñados para ser utilizados cerca de un
televisor, sin embargo, con algunos televisores y combinaciones de
instalación es posible que la imagen se distorsione.
Si ocurre esto, apague el televisor durante unos 30 minutos.
La función de desmagnetización del televisor deberá corregir el
problema. Si persiste el problema, separe más los altavoces del televisor.
No tocar los diafragmas, de lo contrario se ocasionarán
distorsiones.
Alejamiento de objetos magnetizados
Las tarjetas magnetizadas, las tarjetas de bancos, los pases de
viajeros, etc., pueden estropearse si se dejan demasiado cerca de
los imanes de los altavoces. Los relojes también pueden ser afectados.
Evite ubicaciones como las indicadas a continuación.
Expuestas a los rayos solares
Próximas a dispositivos de calefacción u otras fuentes de calor
Donde la humedad sea excesiva
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SBHTS250 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SBHTS250 in the language / languages: English as an attachment in your email.

The manual is 2,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info