536127
12
Zoom out
Zoom in
Previous page
1/32
Next page
ENGLISH
ESPAÑOL FRANÇAIS
SVENSKA
RQT5461
12
Operation
Set the low pass filter, volume and phase to suit characteristics of the
speaker and SB-AS100 combination.
1 Set [POWER] to the “ ON” position.
The unit is now in standby mode and the POWER indicator
turns red.
When a signal is received the unit turns ON automatically and
the indicator turns green.
The unit automatically switches to standby if a signal is not
received for approximately two (2) minutes.
2 Set [LOW PASS FILTER] to a suitable
frequency. Refer to “Frequency re-
sponse by LOW PASS FILTER setting”.
3 Set [VOLUME] to a suitable level. Refer
to “Frequency response by VOLUME
setting”.
4 After playing some music, set [PHASE]
to “ NORMAL” or “ REVERSE”,
whichever position allows playback to
sound normal.
For your reference:
If subwoofer and front speaker phase are the inverse of one
another, they will tend to cancel each other out. Playback will
not be normal and sounds will seem muffled.
When settings are complete
The only operation you should have to perform daily is press [POWER]
to turn the unit ON/OFF.
If you reposition the system and the acoustics change, reset the unit
as necessary.
Note
If the volume output is too loud, this unit’s amplifier can be clipped,
causing output to sound unusual. Reduce the volume of the receiver
or amplifier or the volume of this unit if this occurs.
Front
Lado delantero
Avant
Framsida
Rear
Lado trasero
Arrière
Baksida
Operación
Ajuste el filtro de paso bajo, el volumen y la fase para que se conformen
con las características de la combinación del altavoz y el SB-AS100.
1 Ponga [POWER] en la posición “
ON”.
El aparato está ahora en el modo de espera y el indicador
POWER se vuelve rojo.
Cuando una señal es recibida el aparato se enciende (ON)
automáticamente y el indicador se vuelve verde.
El aparato se cambia a espera automáticamente si una señal
no es recibida durante aproximadamente dos (2) minutos.
2 Ajuste [LOW PASS FILTER] a una
frecuencia apropiada. Refiérase a
“Respuesta de frecuencia por el ajuste
del FILTRO DE PASO BAJO”.
3 Ajuste [VOLUME] a un nivel apropiado.
Refiérase a “Respuesta de frecuencia
por el ajuste de VOLUMEN”.
4 Después de reproducir algo de música,
ajuste [PHASE] a “ NORMAL” o a
REVERSE”, cualquiera que sea la
posición que permita la reproducción
de sonido normal.
Para su referencia:
Si las fases del subaltavoz de bajos y del altavoz delantero
son la inversa del uno y del otro, tenderán a anularse el uno al
otro. La reproducción no será normal y los sonidos parecerán
apagados.
Cuando los ajustes están completos
La única operación que Ud. deberá realizar diariamente es oprimir
[POWER] para encender y apagar el aparato.
Si Ud. reubica el sistema y la acústica cambia, reajuste el aparato
como fuera necesario.
Nota
Si la salida del sonido está demasiado alta, el amplificador de esta
unidad podrá bloquearse, haciendo que la salida suene mal. Si ocurre
esto, reduzca el volumen del receptor, el del amplificador o el de este
aparato.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Technics SB-AS100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Technics SB-AS100 in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Technics SB-AS100

Technics SB-AS100 User Manual - English - 4 pages

Technics SB-AS100 User Manual - English - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info