1. Enable Motion Detect. See Figure 11-14.
2. Enable Advanced config. See Figure 11-14.
3. Now you can set the following settings:
Period: Here you can set motion detect period. System
only enables motion detect operation in the specified
periods. Note: System only supports 6 periods in one
day. Save the settings after changing.
Anti-dither: Here you can set anti-dither time. The value
ranges from 0 to 100s. The anti-dither time refers to the
alarm signal detected lastly. After 1s, if system detects
another alarm signal, it can generate an alarm since
the anti-dither time is out.
Sensitivity: Sensitivity can be set in the range from 0 to
100.
Region Setting: Here you can set motion detection
region. Then click on the start point of the area you
want to select and drag to select the area. Depending
on your given environment this settings can be vary. In
this case a subjective setting by the customer is
requested!
After you completed the setup remember to click the save
button to save current setup. See Figure 11-15.
