319862

Team st 7 et Manual

10
Zoom out
Zoom in
Previous page
1/28
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
10 TEAM ST 7 ET - 070807
Assembly page 10/28
Fax +32 2 359 95 50
Using the appliance when not all the filters are installed properly and in good shape might
damage the appliance. No guarantee claims will be accepted for damages due to that
reason.
ASSEMBLING THE VACUUM CLEANER
Remove all packaging material from the appliance and its accessories.
Insert the connection piece (G) of the flexible hose (B) into hose connection inlet on the
front part of the appliance (Fig. 1). Press until it clicks. To remove the flexible hose, press on
the two release buttons of the connection piece and pull it out of the appliance.
Fit the telescopic tube (D) to the handle (A) (Fig. 2).
Fit the telescopic tube to the floor brush (E) or other accessory (Fig. 3).
You can adjust the length of telescopic tube by pressing its button (Fig. 4).
The floor brush is ideal for the daily cleaning of carpets and hard floors.
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
The appliance is delivered with the following accessories:
a crevice tool: for radiators, crevices, corners, baseboards
and between cushions.
an upholstery brush: for furniture, Venetian blinds, books, lamp
shades and shelves
OPERATION
Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark. Switch on the appliance by pressing the ON/OFF switch.
You can adjust the suction power manually with the wind force adjuster (C), or with the
electronic power control switch (L). Use a low suction power for furniture and other
delicate surfaces and use high suction power for fitted carpet and other floors.
AFTER USE
Stop the vacuum cleaner by pressing the ON/OFF switch (I).
Unplug the appliance from the power supply.
Simply press the cable rewind button (M) to activate the cable rewind mechanism.
For hygienic reasons, empty the dust container after each use if possible (see "Cleaning
the dust container and the filters" section)
CLEANING THE DUST CONTAINER AND THE FILTERS
The filters guarantee you fresh air when vacuum cleaning. Filters that are maintained properly
will allow your appliance to keep its maximum suction power. The dirtier the filters, the weaker
the suction power will be. It is necessary to clean the filters regularly to avoid operation
problems. The filtration system consists of the following elements:
A centrifugal filtration generated by the movement of the air in the dust container.
Therefore it is necessary to empty the dust container regularly.
An accordion filter that filters the smaller dust particles.
A filter in the upper part of the filtration unit of the dust container.
A motor protection filter inside the appliance, behind the dust container.
A supplementary air filter behind the grid in the back of the appliance that filters the dust
particles coming from the motor.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team st 7 et at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team st 7 et in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info