Manual Team ST 49 (page 10 of 20) (English, German, Dutch, French)

487585

Zoom out

Zoom in

1/20



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

10 TEAM ST 49 T - 101202

Assembly page 10/20

Fax +32 2 359 95 50

CLEANING THE FILTERS

Filters

The filter system consists of: 1 cyclone filter to vacuum the smallest particles (in the dust

container)

2 motor filters (on top of the dust collector)

1 air filter, to vacuum the smallest particles (at the back of the

appliance)

It is necessary to clean the 3 last filters regularly to avoid operating problems.

Motor filter

To clean the motor filters (filters situated under the lid of the dust collector), switch off the

appliance, take out the dust collector and turn its lid anticlockwise to take it off. Take the

bracket with the white filter and also remove the black filter to wash them both in soapsuds

(approximately every 3 months). Rinse the filters and let them dry. When the filters are

completely dry, put them back in the appliance. To do so, put the black filter and the bracket

with the white filter back in place correctly. Then put the lid back on, making sure that the lugs

of the lid fit into the slots of the dust collector, and turn the lid clockwise gently to lock it in

place. Make sure that the handle is aligned with the decorative part of the dust collector.

Air filter

 This air filter (situated behind the grid at the back of the appliance) guarantees fresh air

during cleaning. It should be replaced approximately every 3 months (depending on the

operating frequency).

 Switch off the appliance, open the grid, remove the filter and clean it in soapsuds. When it

is dry, put it back and close back the grid.

NOTE: After a certain number of cleanings the filters will be damaged or impossible to get back

in their initial shape. In such case, please contact the nearest customer service to obtain new

filters.

Cleaning the dust collector

 Press the release button of the dust container and pull the dust container out.

 Turn the lid of the dust collector anticlockwise to take it off and remove the motor filters.

 Put your fingers into the two half circles indicated by an arrow and turn anticlockwise

gently. Then pull to take the cyclone filter out.

 You can unscrew the plastic bottom part to rinse it with water. Screw it back on after

cleaning.

 Clean the inside of the dust collector, the lid and the cyclone filter with a damp cloth or

sponge, but make sure they are totally dry before using the appliance again.

 When the dust collector and its lid are completely dry, put the cyclone filter back into the

dust collector and turn the cyclone filter clockwise gently to lock it in place, making sure

that the “triangle” of the filter is right next to the opening of the dust collector. Put the

motor filters back in place and put the lid back on the dust collector in a correct way. Put

the dust collector back in the appliance until it clicks into place.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Team ST 49 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Team ST 49 Manual

Product: