487302

Team ST 3 ET Manual

10
Zoom out
Zoom in
Previous page
1/20
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10
Assembly page 10/20
Fax +32 2 359 95 50
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power socket before fitting or removing accessories.
Insert the hose connector (F) into hose connection inlet of the front cover (G) until it locks
(Fig. 1). To remove the hose, press the release buttons of the hose connection and pull at
the hose.
Fitting the telescopic tube to the handle (Fig. 2).
Fitting the telescopic tube to the floor brush (Fig. 3).
You can adjust the length of telescopic tube according to your own size. To do so, hold
the ring of the tube with one hand, and turn the lower tube a quarter of a turn clockwise.
Then pull the lower part of the tube till it reaches the desired length. To lock the tube at
the desired length, turn it a quarter of a turn anti-clockwise.
The floor brush is ideal for the daily cleaning of carpets and hard floors. It has two different
settings (Fig. 4)
Setting with the bristles inside for cleaning carpets.
Setting with the bristles outside for cleaning hard floors.
OPERATION
Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark.
Plug in the appliance. The power light (M) will come on, indicating that the appliance is
ready for use. Switch it on by pressing the ON/OFF pedal.
It is advisable to set the electronic power regulator to MIN before switching the appliance
on. By turning the regulator button, the suction power can be adjusted. Use high suction
power for carpets and hard floors, and low suction power for delicate surfaces such as
furniture or curtains.
When you use the floor brush, make longitudinal to and fro movements (do not make
lateral movements) and insist on the places that are dirtier, always keeping the sole of the
floor brush in contact with the surface you want to vacuum. To clean under low pieces of
furniture, hold the handle (A) and make a quarter of a turn with the hinge of the floor
brush to put it in its lowest possible position. Make sure you still keep the sole of the floor
brush in contact with the surface you want to clean.
Additional attachments are supplied to allow you cleaning all possible surfaces:
a crevice tool for surfaces that are hard to reach
a small brush for furniture and delicate surfaces
You will find these attachments in the accessory compartment (L) of the vacuum cleaner.
These attachments can be mounted on the handle or on the tube.
The handle of the tube possesses a wind force adjuster that you can open or close to
adjust the suction power. This feature comes in addition to the electronic power regulator.
WHEN CLEANING IS FINISHED
Stop the vacuum cleaner by depressing on the switch button.
Disconnect plug from electrical outlet.
Simply press lightly with your foot on cable rewind button on top of cleaner. If the cord
does not enter completely in the appliance, pull 50 cm of the power cord out of the
appliance and try again.
REPLACING THE DUST BAG AND CLEANING THE FILTERS
The filter system consists of: 1 Motor filter
1 Hepa filter, to vacuum the smallest particles
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team ST 3 ET at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team ST 3 ET in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info