487325

Team ST 29ET Manual

10
Zoom out
Zoom in
Previous page
1/31
Next page
Generated by Unregistered Batch DOC TO PDF Converter
2011.3.804.1511, please register!
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don‟t change the page numbering. Keep the language
integrity.
10
Assembly page 10/31
Fax +32 2 359 95 50
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp
plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
ASSEMBLING THE VACUUM CLEANER
Always remove the plug from the power socket before fitting or removing accessories!
Insert the connection wand into hose connection inlet until it locks (Fig. 1).
Connect both parts of the tube.
Fitting the telescopic tube to the handle (Fig. 2).
Fitting the telescopic tube to the floor brush (Fig. 3).
You can adjust the length of the telescopic tube. Grasp the upper tube in order to read
the text on the locking ring (OPEN-CLOSE) and twist the lower tube from right to left to
loosen the locking ring, then pull the lower half down to the desired length, and then
turning the locking ring from left to right to lock the assembly. For storage of the tube
assembly, reverse the above procedure.
Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.
The floor brush is ideal for the daily cleaning of carpets and hard floors.
Press the lever (A) for cleaning carpets.
Press the lever (B) for cleaning hard floors.
The appliance is delivered with a crevice tool: for radiators, crevices, corners, baseboards
and between cushions.
OPERATIONS
Pull out a sufficient length of power cord and insert the plug into the power socket. A
yellow mark on the power cable shows the ideal cable length. Do not extend the cable
beyond the red mark.
It is advisable to set the electronic power regulator to MIN before switching the appliance
on. By moving the regulator button, the suction power can be adjusted.
WHEN CLEANING IS FINISHED
Stop the vacuum cleaner by depressing on the switch button.
Disconnect plug from electrical outlet
Simply press lightly with your foot on cable rewind button on top of cleaner.
REPLACING THE DUST BAG AND CLEANING THE FILTERS
The filter system consists of: 1 Motor filter
1 Air filter, to vacuum the smallest particles
It is necessary to clean the filters regularly to avoid operating problems.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team ST 29ET at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team ST 29ET in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info