Manual Team SIS 6 (page 10 of 40) (English, German, Dutch, French, Italian, Portuguese, Spanish)

487282

Zoom out

Zoom in

1/40



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

10 TEAM SIS 6 - 060314

Assembly page 10/40

Fax +32 2 359 95 50

IMPORTANT SAFEGUARDS

 Please read these instructions carefully before using the appliance.

 Always place the base of the appliance on a stable ironing board, table or on the

ground.

 Check that your mains voltage corresponds to that stated on the rating plate of the

appliance.

 Only connect the appliance to a mains earthed wall socket.

 To avoid a circuit overload, do not operate another high wattage appliance on the same

circuit.

 If an extension cord is absolutely necessary, a 10-ampere or higher cord should be used.

Never use cords rated for less than 10-ampere. Care should be taken to arrange the cord

so that it cannot be pulled or tripped over.

 Never leave the appliance unsupervised when switched on and especially the steam iron

when it is heating. Keep out of reach of children or incompetent persons.

 Only use the appliance for domestic purposes and in the way indicated in these

instructions.

 Never immerse the appliance in water or any other liquid for any reason whatsoever.

 Never use the appliance near hot surfaces.

 From time to time check the cord for damages. Never use the appliance if cord or

appliance shows any signs of damage but have it checked and repaired by a competent

qualified electrician (*). Should the cord be damaged, it must be replaced by a

competent qualified electrician

(*)

 To avoid the risk of electric shock, do not disassemble the iron or steam tank, take it to a

qualified serviceman for examination and repair. Incorrect re-assembly can cause a risk of

electric shock when the iron or steam tank is used.

 Do not allow power cord and cord binding the base to the steam iron to touch hot

surfaces.

 Never use the appliance outside and always place it in a dry environment.

 Never use accessories that are not recommended by the producer. They could constitute

a danger to the user and risk to damage the appliance.

 Never move the appliance by pulling the cord. Make sure the cord cannot get caught in

any way. Do not wind the cord around the appliance and do not bend it.

 Fully unwind the mains cord and supply hose before starting to iron.

 The steam tank switch should always be turned to “0” before plugging or unplugging the

power cord from outlet.

 REMOVE THE MAINS PLUG FROM THE WALL SOCKET AND ALLOW THE IRON AND THE WATER

TANK TO COOL DOWN BEFORE OPENING, FILLING, EMPTYING, MOVING OR CLEANING THE

LATTER.

 Always unplug the iron and place it on the stand when leaving, even when only for a short

while.

 Burns can occur from touching hot metal parts, hot water, or steam.

 NEVER UNSCREW THE CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE

MAINS WALL SOCKET AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.

 Always place the iron on the base of the appliance, on the therefore foreseen place. Do

not place iron by its rear cover. Be sure that it doesn‟t come in contact with flammable

materials or with the mains cord.

 Never fill the steam tank with vinegar, descaling agents or other chemicals.

 Before using for the first time remove any sticker or protective foil from the soleplate. Clean

the soleplate with a soft cloth.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Team SIS 6 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,52 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Team SIS 6 Manual

Product: