487096

Team KM 45T Manual

10
Zoom out
Zoom in
Previous page
1/44
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
10 TEAM KM 45 T - 100127
Assembly page 10/44
Fax +32 2 359 95 50
Your coffee maker will switch off automatically 2 hours after it has stopped brewing
coffee.
PROGRAMMING THE COFFEE MAKER
To programme your coffee maker to brew fresh coffee at a preset time, first follow steps 1 to 4
in the “PREPARATION OF COFFEE” section.
Make sure the coffee maker’s clock is set to the right time.
Press the PROG button. The clock will now display 12:00. Keep the PROG button pressed down
(the word TIMER appears on the bottom of the LCD display) and use the HOUR and MIN
buttons to set the desired brew time. Once the setting is finished, let go of the PROG button.
The programming time will disappear and will be replaced by the clock time.
Press the START/STOP button once to activate the preset brew cycle. The AUTO light will
illuminate and “AUTO” will appear on the LCD display when the brew time is properly set.
When your preset brew time is reached and the coffee maker starts its brew cycle, the AUTO
light will go out and the red “On” pilot light will illuminate.
As with the regular brew cycle, an automatic two-hour keep-warm cycle will commence after
your coffee maker has finished brewing. When the 2 hours are over, the coffee maker will
automatically shut itself off.
Note: to check the programming time after you have set it, press the PROG button and it will
be displayed.
USE COMFORT
When you remove the carafe from this appliance, a non-drip valve will automatically
operate to stop any drops of coffee dripping onto the hotplate. Replacement of the
carafe automatically opens the non-drip valve and allows any remaining coffee to filter
through into the carafe.
When the water tank is empty, wait a few seconds before removing the carafe in order to
let the water in the filter flow totally.
Once the coffee ready, you can keep it warm by letting it on the hotplate. This will start to
heat up as soon as the coffee maker is on (red “On” pilot light on). With the automatic or
the manual operation, the duration won’t exceed about 2 hours because your coffee
maker will switch off automatically after that.
Never put an (almost) empty jug back on the hotplate when the latter is still hot.
Caution: when you switch your coffee maker off, the hotplate will also switch off, but it will
still stay hot for a short while. So pay attention and wait until the hotplate has completely
cooled down before cleaning or storing the appliance.
DESCALING AND CLEANING
Descaling the coffee maker prolongs its lifespan. For decalcification, only use products
especially made for the decalcification of coffee makers and follow their instruction
manual carefully.
Never put any part of the appliance in the dishwasher. Clean the jug with soapy water
and rinse it with clear water.
The filter holder of your coffee maker is removable in order to clean it more easily under a
water pipe for example but also to avoid the manipulation of a dirty paper filter.
To clean the plastic parts of the appliance, use a humid, non-abrasive cloth.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team KM 45T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team KM 45T in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info