487088

Team KM 35 Manual

7
Zoom out
Zoom in
Previous page
1/20
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
7
Assembly page 7/20
Fax +32 2 359 95 50
INITIAL OPERATION
When you use your appliance for the first time, pour fresh water into the water tank
(without coffee) and switch on the appliance.
Once all the water has passed through, switch the appliance off and let it cool down.
When it is cold enough repeat the process with fresh water. Repeat this process 3 times.
PREPARATION OF COFFEE
Open the lid of the water tank and filter holder (7).
Pour the desired amount of water into the water tank (8). Make sure not to overfill by filling
maximum 10 cups of water. The number of cups can be read from the water level
indicator.
Insert a paper filter or permanent filter (depending on the model) in the filter holder (6)
and add the desired quantity of ground coffee (approximately 6g per cup).
Never forget to close the lid (7) before switching on your coffee maker.
Put the jug with closed lid on the hotplate.
Switch on the coffee maker. The pilot light (9) of the switch will be illuminated, indicating
that your appliance is in use. Thanks to the keep warm function, your coffee is warmed up
as long as the appliance is switched on and the jug (3) is situated on the hotplate (2).
However, we advise you not to let the appliance switched on more than 2 hours and
make sure that you never let an empty jug on the hotplate (2). The hotplate will only stop
heating up when the switch is in OFF position.
When the brewing process is over, remove the jug from the hotplate; pour the desired
amount of coffee and put the jug with the remaining coffee back on the hotplate.
Note: thanks to the drip stop, you can also remove the jug during the brewing process to
take a cup of coffee. However, the brewing process will not be interrupted, so make sure
to put the jug back on the hotplate within 30 seconds, otherwise the water might overflow
out of the filter basket.
DESCALING AND CLEANING
We advise you to descale the coffee maker to prolong its life span. For descaling only use
products especially made for descaling of coffee makers and follow their instruction
manual. Then rinse the appliance twice with fresh water, without coffee powder.
Guarantee claims will not be accepted for appliances that have not been cleaned well.
Never use a dishwasher to clean the jug. Just clean it in soapsuds.
To clean the plastic parts of the appliance, use a damp, non abrasive cloth.
PRACTICAL HINTS
When you notice that the coffee making process is longer than it should be it is probably time
to decalcify the appliance. Do not wait until the situation gets worse. The decalcifying
frequency depends on the amount of lime in water and therefore can be different from family
to family. Therefore it is important to pay attention to this. A good maintenance of your
appliance will prolong its lifespan. Guarantee claims will not be accepted for the replacement
of a heating element full of scale.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team KM 35 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team KM 35 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info