487072

Team KM 16 Manual

8
Zoom out
Zoom in
Previous page
1/16
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
8
Assembly page 8/16
Fax +32 2 359 95 50
INITIAL OPERATION
When you use your appliance for the first time, pour fresh water into the water tank (without
coffee) and switch on the appliance.
Once all the water has passed through, switch the appliance off and let it cool down. When it
is cold enough repeat the process with fresh water. Repeat this process 3 times.
SETTING THE CLOCK
Connect the plug to an outlet. The time "12:00" will flash on the display.
To set the clock, press "PRO" once, "SET TIME" will appear on the left upper part of the
display. Press several times on "HR" to set the hours and on "MIN" to set the minutes.
After approximately 5 seconds the words "SET TIME" will disappear from the display,
meaning that the clock is set.
If you wish to change the setting, repeat the steps above.
MANUAL OPERATION
Open the lid of the water tank (9).
Pour the desired amount of water into the water tank (7). Make sure not to overfill by
respecting the maximum level indicated (8) on the water tank.
Swing the filter holder (1), insert a paper filter or permanent filter (depending on the
model) and add the desired quantity of ground coffee. Replace the filter holder, making
sure it is placed correctly.
Never forget to close the lid of the water tank before switching on your coffee maker.
Switch on the coffee maker by pressing the on/off switch (10). The red pilot light will be
illuminated, indicating that your appliance works.
Your appliance has a hotplate (6) that allows keeping the coffee hot for maximum 2
hours. After 2 hours your appliance switches off automatically (the red pilot light switches
off too). This is a safety device in order to avoid that your appliance works too long, which
can damage it.
When you remove the jug from the appliance, a non-drip valve (2) will automatically
operate to stop any drops of coffee dripping onto the hotplate. Replacement of the
carafe automatically opens the non-drip valve and allows remaining coffee to filter
trough into the jug.
When the water tank is empty, wait a few seconds before removing the carafe in order to
let the water in the filter flow totally.
To brew new coffee turn off the unit for 10 minutes, clean the carafe and the filter holder
and restart the process.
Attention: when you switch your coffee maker out, the hot plate will also cut out, but it will
still stay hot for a short while. So pay attention wait until the hot plate has completely
cooled down before cleaning or storing the appliance.
PROGRAMMING THE COFFEE-MAKER
Your coffee maker has a 24 hours timing, but the programmed clock remains in the memory as
long as you don’t modify it.
Check the time displayed on the clock.
Open the lid of the water tank (9).
Pour the desired amount of water into the water tank (7). Make sure not to overfill by
respecting the maximum level indicated (8) on the water tank.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team KM 16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team KM 16 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info