.............................................................................................
35
CHANGE OF BATTERY
Your new radio-controlled wristwatch has a lithium battery (type
CR1620), which has a service life of approx. 4 years.
If the seconds or date display is flashing, the battery is used up.
Replace by a new battery in the next few days.
IMPORTANT: Do not leave an empty battery for a longer period of
time in the watch, as gas might exit and damage the
watch.
After a change of battery, the display shows . Press the
recessed button several times to set the
hands to exactly 12.00 o'clock. If you keep the button pressed, the
hands advance fast forward.
To finish, press the right push-button briefly. The watch switches to
reception mode and after several minutes sets itself to the correct
time.
............................................................................................
34
PROBLEMS / RESET
If the watch will not set itself correctly or does not work as de-
tailed above, it can be reset.
If you are outside the transmitter range:
Proceed as detailed under “Setting the time outside the range of
the time signal transmitter” above.
If the watch is within the transmitter range (approx. a 1500 km
radius around Frankfurt/Main, Germany):
Press simultaneously both the recessed button and the push-
button for about 3 seconds, until the display goes blank. After
releasing the buttons will appear in the display. Press the
recessed button several times to set the hands to exactly 12.00
o'clock. Holding the button down causes the hands to move fast
forward. To finish, press the right push-button briefly. The display
changes from to and the watch switches to recep-
tion mode. After several minutes the watch will set itself to the
correct time.
