794185
9
Zoom out
Zoom in
Previous page
1/24
Next page
9
3. Connect the outside aerial or cable network to the ANTENNA IN socket at the
back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for connecting
anexternalaerialorotherequipmentttedwithamodulator(videorecorder,
satellite receiver, etc.). We recommend that you do not connect other
equipment (video recorder, satellite receiver, etc.) to your TV set to begin
with, so as not to complicate the set-up procedure with the additional steps
involved.Connectthemwhenyouhavenishedsettingupthechannels.
4. When powered on, the TV will be turned on directly or be in standby mode.
If the TV set is in standby mode, press the standby button on the remote
control or on the TV set to turn on the TV.
Note: The location and name of the power button on the TV may vary
according to TV model.
Connections and Setup
Switching off
To put the TV set into standby mode, press on the remote control or on the TV, the TV set remains powered up,
but with low energy consumption.
To switch off the TV set, disconnect the mains plug from the mains outlet.
Switching on
Follow the instructions on this page on how to switch on your TV set and the remote control before going on to follow-
ing pages describing how to use the channel set-up procedure.
1. Insert three AAA batteries in the remote control.
Precautions on using batteries:
-Onlyusethebatterytypesspecied.
- Make sure you use the correct polarity.
-Donotmixnewandusedbatteries.
- Do not use rechargeable batteries.
-Donotexposebatteriestoexcessiveheatsuchassunshine,reorsimilar,throwtheminare,rechargethem
ortrytoopenthem,asthiscouldcausethemtoleakorexplode.
- Remove the batteries from the remote control if you are not using it for a long period of time.
2.Connectthepowercabletoamainssocket.(Ifthepowercableisnotconnectedtothetelevision,pleaserst
connect the power cable to the television.) Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do not, under any circumstances, connect it to a
mains socket, as there is a risk of electric shock.
Note: The gures are for representation only. The location of the power socket at the back of the television might
differ depending on the model.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TCL H9600CDS series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TCL H9600CDS series in the language / languages: English as an attachment in your email.

The manual is 10.54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info