15
DETAILED EDIT DESCRIPTIONS
VoiceDoubler’s clock to the incoming clock
(Ext.) or b) your input is analog and you are
using the digital output to feed another device
at a specific clock rate. The digital output is
always on regardless of the Input setting.
S4
Status and Tuning Reference - When you are
using VoiceDoubler’s digital outputs to drive a
downstream device, The StatusBits parameter
changes the output format from AES/EBU to
S/PDIF when required. The TunRf (Tuning
Reference) setting adjusts the Overdub
Correct frequency to compensate for vocals
sung to backing tracks not tuned to A=440Hz.
S5
MIDI Channel and System Exclusive ID - If you
are using an external MIDI device to change
presets or to control VoiceDoubler, the MIDI
channels of the two devices should match. The
SysexID parameter is only used when you
have multiple VoiceDoublers on a MIDI In/Thru
chain and are using an editor program to make
changes in one and not the others.
S6
MIDI Filter and CC enable - The MIDI Filter
allows selected parts of the MIDI stream to be
ignored by VoiceDoubler. The CC setting
enables or disables MIDI continuous
controllers. These CCs offer convenient
remote control of certain settings from a MIDI
sequencer or remote control surface. See the
MIDI Implementation Chart at the end of this
manual for details.
S7
MIDI Dump - This screen allows you to copy
presets and setup data to an external MIDI
device for safe storage or editing. Choose from
the range of values with EDIT 1 knob and
push the Data wheel to execute the dump or to
cancel.
Restoring individual presets is done by
sending them from an editor or sequencer via
MIDI; the only setup required by VoiceDoubler
is that the SysEx filter (S6) be turned off.
Restoring an entire bank of user presets
requires that the user bank be erased prior to
sending the MIDI data. To erase the user bank
see the following description.
S8
Utility - This screen allows you to return
VoiceDoubler to its factory defaults. Choose to
restore all the values for the Setup menus or
to erase the User presets with EDIT 1 and
then push on the Data wheel to execute.