727649

Taurus Roner Clip Manual

13
Zoom out
Zoom in
Previous page
1/32
Next page
TROUBLE SHOOTING FAQ
Noise Under the normal operation the system will hum due to the motor,
impeller and cooling fan in operation.
Grinding noise The stainless steel skirt is loose. Push the stainless skirt up into
the guide groove and turn to the right until you hear a click. With
the skirt secure, the noise will go away.
There also might be the chance the stirring shaft was inadver-
tently bent. In this case, unscrew the bottom pump disk and gently
push the impeller until it is centered.
Slurping noise Your pump has formed a water vortex like when you are empting
out a bathroom sink or tub. Add more water or gently disturb
water with a spoon. There is no sure way to eliminate a vortex
from forming due to the pump rotation but usually will go away on
its own.
Gurgling + whoosh noise The pump is sucking air - add more water. You should also see
small bubbles in your tank.
Food damage The pump’s water jet is cracking eggs or damaging sh llets:
Turn the pump outlet to face the container wall; this will greatly
temper the ow of the pump output. It is also good practice to
bag eggs to prevent them from being “blown” around in certain
containers.
System will not turn out Check power plug and breakers
Low water level alarm (EE1) Add more water, the water level can be dropped during operation
by the pump due to water turbulences
Low water level alarm turns
on after a few seconds of
operation (EE1)
Add more water – The pump generates “waves” – sometimes
these waves will cause the water level at the sensors to uctuate
up and down. The waves sometimes drop the water level right
under the sensor and will cause a low water alarm. This is normal
and you just need to add more water.
Temperature read does not
match thermometer
Low Temperature Thermal Circulators are calibrated to a scientic
platinum primary standard which is far more accurate than store
thermometers.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Taurus Roner Clip at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Taurus Roner Clip in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info