photos (6MP
or 8MP resolution, depending on model), or video clips (720p, 10 seconds length).
The Tasco Trail Camera consumes very little power (< 0.5mA) in a stand-by (surveillance) state. This means it can
deliver up to six months stand-by operation time when the device is powered by eight AA alkaline batteries, and
up to twelve months utilizing eight lithium AA batteries (30 images per day, 15 w/flash).
Once motion in the monitored area is detected, the digital camera unit will be triggered at once (typically less than
1 second) and then automatically take photos or videos (your choice). The Tasco Trail Camera is equipped with
built-in infrared (IR) LEDs that function as a flash, so that it delivers clear photos or videos (in black & white) even
in the dark, and it can take color photos or videos under sufficient daylight. The Tasco Trail Camera is designed for
outdoor use and is water resistant.
PARTS and CONTROLS
Release the two latches on the right side of the camera and swing the front cover over to the left to access the
controls. A 3-way power/mode switch is used to select the main operating modes: OFF, AIM, and ON (Fig. 1)
When the power switch is set to the AIM middle position, the camera is in Setup Mode. The AIM position can also
be used to verify the area the camera will monitor. The LCD Display will show the camera’s current settings in
Setup Mode. The Up, Down and OK keys are used to set the date and time (to be imprinted on each photo/video),
change the interval or “detection delay” time between images while an animal remains in range of the camera’s
sensor, select Photo or Video capture mode, set a camera ID number for your reference, and format the SD card
(erase all files). Once you setup the camera, switch it to ON for normal operation.
